User Manual

DTB-H550F
ENG-39
ENG
DTB-H550F
ENG-38
DIGITAL TERRESTRIAL HDTV RECEIVER
OPERATING THE RECEIVEROPERATING THE RECEIVER
4.2 Region Selection
You can set your region according to your location.
Select “Region Selection” in the System menu.
Select the region you want by using
or
key.
Region: New South Wales, Northern Territory,
Queens land, South Australia, Tasmania,
Victoria, and Western Australia.
Press the SELECT () key for confirmation.
Press the RETURN () key to cancel your work or go
back to the previous menu.
Press Exit to exit the menu.
NNoottee : 1. What is “Region”?: This is a function that automatically changes the system time
according to the corresponding time region.
2. In case that the STB is moved to other region, do “Channel Auto Scan” in the
Channel menu to set the new channels.
4.3 Status
If you have to contact your service provider or a service
center they might ask for information available from this
menu.
Select “Status” in the System menu.
Press the RETURN () key to cancel your work or go
back to the previous menu.
Press Exit to exit the menu.
4.4 Signal Detection
You can obtain the signal strength and reception quality
of an incoming RF channel.
Select “Signal Detection” in the System menu.
Select the RF channel you wish to view by using the
or
keys and press the SELECT () key to start
signal detection.
RF Channel Range: From 6 to 69.
Press the RETURN () key to cancel your work or go
back to the previous menu.
Press Exit to exit the menu.
NNoottee : The signal strength and reception data may not
display on the screen when the incoming signal is
poor (even when it exists), depending on the
broadcasting conditions.
4.5 Factory Reset
This is to restore the factory set values in case the user
has encountered some problems after changing any
values of channel data and others which may be in error.
Select “Factory Reset” in the System menu.
Input your PIN Code using NUMERICAL key,
then press the SELECT () key. It asks for
your confirmation.
If you want to perform a reset, press the
SELECT () key.
The receiver will automatically restart and the factory
default settings will be restored.
If you don’t want to perform a reset, press the
RETURN () key to cancel your work or go back to
the previous menu.
NNoottee : This cause your previous settings to be deleted!
0401 DTB-H550F_ENG 4/1/05 3:18 PM Page 38