Docs

FOR LEFT AND RIGHT SIDE
6. Insert new exhaust Duct Front
supplied with kit into blower
housing. Rotate the duct to
engage duct clip into tab
extending up from base frame.
7. Insert the elbow supplied in
the kit into exhaust duct (F)
and through the left or the right
(Electric models only) toward the
outlet hole depending on which
direction to be exhausted.
8. For side venting (left or right)
insert the Exhaust Duct Back into
the elbow and out cabinet side.
 For left side venting use “Duct
Back-Left”, for right side venting
use “Duct Back-Right” separately.
 For these models DV56H9000E*, DV56H9100E*, use the “Duct-
Back Left” (BACK-LEFT) instead of “Duct-Back Right” for RIGHT
SIDE VENTING.
9. Tape each joint with the duct tape.
Caution: Internal duct joints must be secured with tape;
otherwise, they may separate and cause a safety hazard.
10. Drill a 1/8˝ hole using a hand drill
in the frame and fix the bracket of
the duct by fastening the screw.
 The screw is not supplied with the
kit. You may use the screw that
you remove in the step 3.
11. Reinstall the exhaust duct cover
on rear of cabinet.
12. Insert the vent cap supplied with
the kit into rear exhaust hole left
by old duct.
FOR BOTTOM PLATE
6. Assemble The Duct Front-Bottom
and The Elbow.
7. Insert the assembled elbow and
duct into the hole at the bottom
as shown by the figure.
8. Pull the Duct Front-Bottom
forwards to insert it into the Fan
Housing.
9. Put the duct over on the tab
extended from the base frame.
10. Wrap up the joint with duct tape.
11. Tape on the joint between the
elbow and internal duct.
Caution: Internal duct joints must be secured with tape;
otherwise, they may separate and cause a safety hazard.
12. Reinstall the exhaust duct cover
on rear of cabinet.
13. Insert the vent pipe cap supplied
with the kit into rear exhaust hole
left by old duct.
Type A
Type A
Type B
Type B
DV-1A_XAA-01052Y-05_EN.indd 2 2016-01-29 �� 12:37:56