Clothes Dryers Owner’s Instructions DV4008J DV4006 Code No.
Table of Contents Safety Instructions 2 Installation Instructions Installation Instructions Exhaust Exhaust length calculations Exhaust directions Special accessory Special installation requirements 4 5 5 5 6 Operating Instructions, Tips Control panel(DV4006) Control panel(DV4008J) Polyester Knits & Permanent Press Drying Tips Loding clothes 7 8 9 9 Care and Cleaning Cleaning filter Dryer Exterior Dryer Exhaust Inside the dryer cabinet Problem Solver Questions? Use this problem solver 10 10 11 11
Safety Instructions Read all instructions before using this appliance Warning - It is extremely important that you read and adhere to the following instructions. Failure to do so could cause bodily injuries and/or property damage due to fire. • Use this appliance only for its intended purpose as described in this Owner’s Manual. - This dryer must be properly installed and located in accordance with the Installation Instructions before it is used. - Properly ground to conform with Local Codes.
Safety Instructions • Clean the lint filter before each load to prevent lint accumulation inside the dryer or in the room. DO NOT OPERATE THE DRYER WITHOUT THE LINT FILTER IN PLACE. • Keep the area around the exhaust opening, and around and underneath your appliances free from the accumulation of combustible materials, such as lint, paper, rags, chemicals, etc. • Regularly inspect the exhaust duct to be sure it has not been crushed or otherwise restricted.
Installation Instructions INSTALLATION INSTRUCTIONS EXHAUST Installation and service must be performed by a qualified installer or service agency. IMPORTANT: Have your dryer installed properly. NOTE: The WARNING and IMPORTANT instructions appearing in this manual are not meant to cover all possible conditions and situations that may occur. It must be understood that common sense, caution, and carefulness are factors that CANNOT be built into the dryer.
Installation Instructions EXHAUST LENGTH CALCULATION Table 1: RECOMMENDED MAXIMUM LENGTH ELECTRIC DRYERS Weather Hood Type Recommended Use only for short run installations ↔4”(10.16cm) ↔2 1/2”(6.35cm) No. of 90° elbows Rigid Metallic Flexible* Rigid Metallic Flexible* 0 1 2 3 14m(46ft.) 11m(38ft.) 9m(31ft.) 7m(24ft.) 9m(30ft.) 7.5m(25ft.) 6m(20ft.) 5m(16ft.) 11m(37ft.) 9m(30ft.) 6.5m(22ft.) 4.5m(15ft.) 7m(24ft.) 6m(20ft.) 4m(14ft.) 3m(10ft.) * Do not use non metallic flexible duct.
Installation Instructions SPECIAL INSTALLATION REQUIREMENTS ALCOVE OR CLOSET INSTALLATION • WARNING: To reduce the risk of fire, this dryer MUST BE EXHAUSTED TO THE OUTDOORS. See EXHAUST INFORMATION section. • Minimum clearances between dryer cabinet and adjacent walls or other surfaces are: 0” either side 1” front and rear • Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52”(132cm). • Closet door must be louvered or otherwise ventilated and must contain a minimum of 60 sq. in.
Operating Instructions, Tips Control panel (DV4006) 1. TIME button Initial time mode of TIME button displays 50 minutes. Push TIME button continuously to change time as follows: 50 minutes → 40 minutes → 30 minutes → 20 minutes → 50 minutes 2. TEMPERATURE button Initial mode is set to OFF at the factory. Push TEMPERATURE button to select LOW temperature and turn the lamp ON. 3. PROGRAM button Initial mode displays CUP BOARD.
Operating Instructions, Tips Control panel (DV4008J) During DRY cycle, displayed remaining time may be increased or decreased. Such a condition is not a system failure, but a DRY function optimization process. Load less than 8lb to get the best drying result. (Max. DRY time is 3 hours.) 1. SIGNAL button Initial mode is set to OFF at the factory, and no completion buzzer makes sound. Push the SIGNAL button to turn the SIGNAL lamp ON and make the completion buzzer sound. 2.
Operating Instructions, Tips Polyester Knits & Permanent Press Drying Tips • DO NOT OVERLOAD- Garments being dried or dewrinkled should tumble freely. • REMOVE CLOTHES PROMPTLY- To help prevent wrinkling, remove clothes from the dryer promptly at the end of the drying cycles. • PLACE ON HANGERS- Permanent press and polyester knit garments look best if placed on hangers after drying. LOADING CLOTHES Don’t overload your dryer. Crowded loads don’t dry efficiently and clothes may be unnecessarily wrinkled.
Care and Cleaning Cleaning filter Clean the filter before every dryer use Slide the grid out as shown Clean the lint filter. Put your moistened fingers at one corner of the filter and wipe in a sideways motion all the way across to the other corner. PULL CLEAN LINT FILTER AFTER EACH CYCLE Do not operate the dryer without the grid in place. Do not operate the dryer without the filter in place.
Care and Cleaning DRYER EXHAUST MAXIMIZE YOUR DRYER EFFICIENCY BY KEEPING THE EXHAUST DUCT CLEAN. 1. Disconnect or Turn off electrical power. CONNECTED TO DRYER EXHAUST HOOD 2. Disconnect duct from dryer. 3. Clean exhaust duct from end where dryer is connected to the exhaust hood using: • the hose attachment of your vacuum cleaner: • a dust rag attached to a pole (for straight stretches) or to a drain cleaning wire (for less accessible turns). Check turns in the exhaust duct for any collected lint.
PROBLEM SOLVER PROBLEM POSSIBLE CAUSE DRYER WON’T START • Dryer unplugged. Make sure power cord is plugged in. • No power to dryer. Check fuses and circuit breakers to make sure dryer is getting current. Most electric dryers use two. • Controls improperly set. Make sure controls are and that the Start button is pressed. Opening the door during operation stops the dryer. To restart, close the door and push the Start button. • Dryer door is open. Close door securely - dryer will not run with door open.
Appendix Warranty Information Limited Warranty for Original Purchaser This Samsung product is warranted by Samsung Electronics Canada, Inc.
