Clothes Dryers Owner’s Instructions DV5008J DV5006 DV5004J DV5002
Table of Contents Safety Instructions 3,4 Installation Instructions Ducting Installation instructions 5 Duct length calculations 6 Exhaust directions 6 Special accessory 6 Special installation requirements 7 Electrical power supply 7 Operating Instructions, Tips Control panel(DV5008J) 8 Control panel(DV5006) 9 Control panel(DV5004J) 10 Control panel(DV5002) 11 Loading clothes 12 Polyester Knits & Permanent Press Drying Tips 12 Program selecting guide 13 Program chart 14 Drying
Safety Instructions Read all instructions before using this appliance Warning - It is extremely important that you read and adhere to the following instructions. Failure to do so could result in bodily injuries and/or property damage due to fire. •Use this appliance only for its intended purpose as described in this Owner’s Manual. This dryer must be: - Properly installed and located in accordance with the Installation Instructions before it is used. - Properly grounded to conform with Local Codes.
Safety Instructions • Clean the lint filter before each load to prevent lint accumulation inside the dryer or in the room. DO NOT OPERATE THE DRYER WITHOUT LINTFILTER IN PLACE. • Keep the area around the exhaust opening, and around and underneath your appliances free from the accumulation of combustible materials, such as lint, paper, rags, chemicals, etc. • Regularly inspect the vent duct to ensure it has not been crushed or otherwise restricted.
Installation Instructions DUCTING INSTALLATION INSTRUCTIONS Installation and service must be performed by a qualified installer or service agency. IMPORTANT: Have your dryer installed properly. NOTE: The WARNING and IMPORTANT instructions appearing in this manual are not meant to cover all possible conditions and situations that may occur. It must be understood that common sense, caution, and carefulness are factors that CANNOT be built into the dryer.
Installation Instructions DUCT LENGTH CALCULATION Table 1: RECOMMENDED MAXIMUM LENGTH ELECTRIC DRYERS Weather Hood Type Recommended Use only for short run installations ↔4”(10.16cm) ↔2 1/2”(6.35cm) No. of 90° elbows Rigid Metallic Flexible* Rigid Metallic Flexible* 0 1 2 3 14m(46ft.) 11m(38ft.) 9m(31ft.) 7m(24ft.) 9m(30ft.) 7.5m(25ft.) 6m(20ft.) 5m(16ft.) 11m(37ft.) 9m(30ft.) 6.5m(22ft.) 4.5m(15ft.) 7m(24ft.) 6m(20ft.) 4m(14ft.) 3m(10ft.) * Do not use non metallic flexible duct.
Installation Instructions SPECIAL INSTALLATION REQUIREMENTS ALCOVE OR CLOSET INSTALLATION • WARNING: To reduce the risk of fire, this dryer MUST BE VENTED TO THE OUTDOORS. See the VENTING INFORMATION section. • The minimum clearances between dryer cabinet and adjacent walls or other surfaces are : 0” either side 1” front and rear • The minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52”(132cm).
Operating Instructions, Tips Control panel (DV5008J) 1. The SIGNALbutton Set to OFF at the factory. When switched on, a buzzer sounds when the current program has finished. Push the SIGNALbutton once to turn on and again to turn off. The indicator labelled with a bell symbol will light when this feature is switched on. 2. The TEMPERATURE button Set to OFF at the factory. Used to switch the drying temperature from high to low. Push the button once to set to low and again to set back to high.
Operating Instructions, Tips Control panel (DV5006) 1. The TIME button When pressed, indicators light up to indicate the running time. Initially the 50 indicator is lit up, then with each press time reduces by 10 mins and the indicators light (eg: 50 minutes640 minutes 630 minutes 620 minutes 650 minutes.) 2. The TEMPERATURE button Set to OFF at the factory. Used to switch the drying temperature from high to low. Push the button once to set to low and again to set back to high.
Operating Instructions, Tips Control panel (DV5004J) 1.The DELAY START button (and on/off indicator) This allows you to delay the start of the selected dryer program in increments of 1 hour for each press. (1 hour626hours 63 hours ... 624 hours 6Cancel.) 2.The TIME button When pressed, the timer displays 50 minutes. By pressing the button, you can reduce the setting to a minimum of 20 minutes when the time jumps to 100(1:40) mins and steps down to 50 mins. 3.
Operating Instructions, Tips Control panel (DV5002) 1.The SIGNALbutton Set to OFF at the factory. When switched on, a buzzer sounds when the current program has finished. Push the SIGNAL button once to turn on and again to turn off. The indicator labelled with a bell symbol will light when this feature is switched on. 2.The TEMPERATURE button Set to OFF at the factory. Used to switch the drying temperature from high to low. Push the button once to set to low and again to set back to high.
Operating Instructions, Tips LOADING CLOTHES • Preparing Laundry Check that all fastenings are closed and that pockets are empty. Place laundry loosely in the drum to make sure that they don’t get tangled. • Sort laundry as follows (Examples) As a general rule, sort clothes by surface texture, fabric, color and weight, as you would for your washer.
Operating Instructions, Tips Programs Cotton Extra Max. Load Example for Heavy weight or mult-layered fabrics Track suits, Towelling materials, bath robes Very Fabrics of medium weight, articles not made up of mult-layers Jeans, Towel laundry, hand towels Cupboard Normal cotton and linen articles Sheets, and pillowcase, tablecloths, cotton trousers Light lightweight materials Cotton shirt and underwear Iron Cotton and linen articles to be ironed.
Operating Instructions, Tips PROGRAM CHART Programs Cotton Extra Max. Load 5kg Low Temp Delay Heating Control Estimated Select Start (Heater Turn Off) Time(3.
Care and Cleaning Cleaning the filter Clean the filter before every use Slide the grid out as shown Clean the lint filter. Put your moistened fingers at one corner of the filter and wipe in a sideways motion all the way across to the other corner. PULL CLEAN LINT FILTER AFTER EACH CYCLE Do not operate the dryer without the grid in place. Do not operate the dryer without the filter in place.
Care and Cleaning DRYER Vent MAXIMIZE YOUR DRYER EFFICIENCY BY KEEPING DUCTING CLEAN. 1. Disconnect or Turn off the electrical power. THE CONNECTED TO DRYER EXHAUST HOOD 2. Disconnect the ducting from the dryer. 3. Clean the ducting from the end where the dryer is connected using: • the hose attachment of your vacuum cleaner • a duster attached to a pole (for straight stretches) or to a drain cleaning wire (for less accessible areas). Check turns in the exhaust duct for any collected lint. 4.
PROBLEM SOLVER PROBLEM POSSIBLE CAUSE DRYER WON’T START • Dryer unplugged. Make sure power cord is plugged in. • No power to dryer. Check fuses and circuit breakers to make sure dryer is getting current. Most electric dryers have two fuses so make sure you check both. • Controls improperly set. Make sure the controls are set correctly and that the Start button is pressed. Opening the door during operation stops the dryer. To restart, close the door and push the Start button. • Dryer door is open.
IN CASE THE NEED FOR SERVICING ARISES -Don't hesitate to call any AS center nearby with your name, address and telephone number when anything wrong with your product occurs.
