User manual

67
GB
About Speaker Setup
To Set the Speaker Balance
1 Press the SPEAKER button.
Each time you press the button, the selection will change as
follows: FL
 C  FR  SR  SL  SU  VOL.
2 Press AMP VOL + and AMP VOL - buttons to adjust the speaker
volume.
The volume can be adjusted to a level between –10 and +10.
To Test the Speakers
1 In Stop mode, press the TEST button.
◆ The test tone will be output to the speakers in the following
order: FL (Front Speaker/L)
 C (Center Speaker)  FR (Front
Speaker/R)
 SR (Surround Speaker/R)  SL (Surround
Speaker/L)
 SU (Subwoofer).
◆ A hissing sound from a speaker indicates that the speaker is
installed correctly.
2 To end the speaker test, press the TEST button again.
➢ • While the test tone is being produced, you can use the VOL
buttons to set the speaker balance for the selected channel.
• While the subwoofer is being tested, a low bass sound of
100Hz or 125Hz will be heard.
To Set the Bass/Treble
1 Press the BASS or TREBLE button.
Each time you press the BASS or TREBLE button, the
corresponding setting will turn on or off.
2 Use AMP VOL + and AMP VOL - buttons to adjust the bass or
treble of the speakers.
The bass or treble can be adjusted to a level between –10 and
+10.
1
1,2
1
1
2
2
2
2
FL
FRONT SPEAKER
LEFT
FRONT SPEAKER
RIGHT
CENTER SPEAKER
SURROUND SPEAKER
RIGHT
SURROUND SPEAKER
LEFT
SUB WOOFER
SPEAKER
C
SUB
WOOFER
FR
SRSL
00444A DVD-CM250/XEU-GB4 5/12/04 1:43 PM Page 67