Operation Manual

English _101
REFERENCE
PROBLEM EXPLANATION/SOLUTION
No audio output.
Check whether you have selected the correct digital output options in the Audio
Output Options menu. (See pages 40~41)
Timer lamp fl ickers
Check there is enough space in the disc or HDD for recording.
Check whether the current disc is recordable or not.
Make sure to check before the start time of recording.
Timer recording does not work properly.
Re-check the recording time and the end time settings again.
Recording will be cancelled if the power is interrupted due to a power failure
or another similar reason while recording.
Cannot copy into USB or vice-versa
Check the USB connection.Disconnect and try to connect again.
Refer to “Compatible USB devices at host port”on page 8.
No HDMI output
Check the Video output is HDMI enabled.
Check the connection between the TV and the HDMI jack of the HDD & DVD
RECORDER.
See if your TV supports HDMI.
Abnormal HDMI output screen.
If snow noise appears on the screen, it means that TV does not support HDCP
(High-bandwidth Digital Content Protection).
HDMI output Jitter.
Check your TV system setup correctly.
Please refer to the user’s manual of your TV.
The remote control doesn’t work.
Point the remote control at the remote control sensor on your HDD & DVD
RECORDER. Allow for proper distance. Remove obstacles between your HDD
& DVD RECORDER and the remote control.
Check whether the batteries are drained.
Check the TV/DVD selection button setting.
Check whether TV control button is selected or not.
I forgot my password for parental
supervision
Press and hold the PLAY/PAUSE (&) buttons on the front panel for more than
10 seconds with no disc in the unit.
All settings including the password will revert to the factory settings. Do not use
this unless absolutely necessary.
Is it possible to change a subtitle and an
audio signal on a recorded disc?
A recorded disc is played with only the subtitle and the audio signal which were
selected during recording
Other problems
Read the table of contents and then fi nd and read the section describing your
problem, follow the instructions given.
Plug your HDD & DVD RECORDER off and on.
If the problem still persists, contact a nearby Samsung service centre.