User Manual

Searching for a Specific Sequence
40 41
GB GB
Searching for a Specific Sequence
Intro Scan
1 After pressing the SEARCH, press the corresponding  or ❷
buttons, until the Intro Scan option is selected.
2 Press the OK or ❿.
3 Press the ➛➛
or
❿❿
buttons depending on the direction
where your desired programme is located.
4 When an Index mark is found the DVD-VCR will playback the
tape for 5 seconds, after which it will continue searching for the
next Index mark.
5 If you want to watch the tape from a particular Index, simply
press
❿
II
.
Index Skip Search:
This feature will enable you to fast forward/rewind to a specific
point on a tape: E.g. if you have recorded 3 different
programmes on a tape and you have rewound the tape to the
beginning, by using this feature you can go directly to the start of
programme 2 simply by pressing the SEARCH button.
1 After pressing the SEARCH, press the corresponding  or ❷
buttons, until the Intro Scan option is selected.
2 Press the OK or ❿.
3 Press the ➛➛
or
❿❿
buttons twice more. This will take
you directly to the start of the desired programme is located.
4 These Index searches can be made forwards: (press ❿❿ ) or
backwards: (press
➛➛ ). ( ➛➛ -20
● ●
0
● ●
+20 ❿❿✌
5 To cancel an Index search simply press the ❿
II
or
■
button.
INTRO SCAN: ➛➛❿❿
INDEX SEARCH : ➛➛ - 6
3
3
VCR
Each time you record a cassette on this DVD-VCR, an “index” is
automatically marked on the tape when recording starts.
The Search function allows you to fast-forward or rewind to a
specific index and start playback from that point. Depending on
the direction selected, the indexes are numbered as follows:
➢ This DVD-VCR uses a standard indexing system (VISS).
As a result, it will recognize any indexes marked by
other VCRs using the same
system and vice versa.
Go To 0:00:00 Stop
Use this feature when you want to search for the 0:00:00 counter
position on a cassette. Press the CLEAR button at the point on the tape
where you want to set the counter to 0:00:00.
The VCR will rewind or fast forward, searching for the 0:00:00 counter
position, and then automatically stop at that position.
1 After pressing the SEARCH, press the corresponding  or ❷
buttons, until the Go To (0:00:00) option is selected.
2 Press the OK or ❿ .
End Search
Use this feature when you want to search for a blank position to record
a program on a cassette.
The VCR will fast forward, searching for a blank position, and then
automatically stop at that position.If the VCR reaches the end of the
tape during end search, the tape will be ejected.
1 After pressing the SEARCH, press the corresponding  or ❷
buttons, until the End Search option is selected.
2 Press the OK or ❿ .
21 12
➞
etc.
Prev
Seq.
Seq. being
played
Next
Seq.
etc.
OK
VCR
1
00282A DVD-V530/XSA-GB2 8/18/03 2:27 PM Page 40