User Manual

68 - English
Recording
Use the PROG/TRK / buttons or number
buttons to select the
stations to record.
1
Making a One Touch
Recording (OTR)
DVD-RAM
DVD-RW
DVD-R
One-Touch Recording (OTR) allows you to add record-
ing time in 30-minute increments up to 9 hours at the
touch of a button.
Start Recording.
Follow the instructions on page 66 to begin
recording.
2
Activate OTR.
While in Record mode, press the REC button
again to activate One-Touch Recording (OTR).
• Record length 0:30 appears on the On-Screen
Display and the DVD Recorder-VCR will record
for exactly 30 minutes.
3
Add Recording Time.
Continue pressing REC to add recording time in
30 minute increments up to 9 hours.
• The DVD Recorder-VCR stops recording auto-
matically when the time has elapsed.
 REC  30  1’00  1’30  2’  2’30  3’
9’
 8’  7’  6’  5’  4’  3’30
4
To enter a G-Code , press the TIMER REC
button. Press the
❷ and ❿or OK buttons to
select
G-Code .
• A message is displayed to allow you to enter the
G-Code .
• If all twelve programmes have been set, the
message Timer is full is displayed. Refer to page
73~74 if you wish to cancel a preset recording.
1
Using the
Feature
Before presetting your DVD Recorder-VCR:
• Switch on both the television and your DVD Recorder-VCR
• Check that the date and time are correct
• Insert the cassette or Recordable DVD on which the
programme is to be recorded (safety tab intact) Up to twelve
programmes can be preset.
Press the numeric buttons to enter the code
opposite the programme that you wish to record
in your television magazine.
• If you wish to correct the G-Code that
you are entering:
- Press the ➛ button until the digit to be
corrected is cleared
- Enter the correct digit
2
G-Code
DVD-RAM(VR)
Enter G-Code number.[0-9]
Disc Manager
Programme
Playlist
Disc Manager
Playlist
G-Code
Programme
DVD-RAM(VR)
Standard Timer
G-Code Extended :Off
Programme
