User Manual

English
English 53
Maintenance
Keep the dryer clean to prevent decreased performance and to lengthen its life.
WARNING
Certain internal parts are intentionally not grounded and may present a risk of electric shock only during
servicing. Service Personnel - Do not contact the following parts while the appliance is energized: Control
board and inlet valve.
Vent sensor
The dryer features a vent sensor that detects and notifies you when it is time to clean the ductwork. The
indicator lets you know the status of the duct.
Level
Indicator
Status Action
0 Off The ductwork is not clogged.
1 On
• The duct or lint filter is clogged.
• The pressure applied to the duct
is high because the duct is too
long or bent.
• Check the lint filter or duct and
clean if necessary.
• Check the duct connections and
shorten or straighten the duct if
necessary.
2 Blinking
• The duct or lint filter is severely
clogged.
• The pressure applied to the duct
is very high because the duct is
too long or bent.
• Check and clean the lint filter or
duct and make sure they are not
clogged.
• Check the duct connections and
shorten or straighten the duct
work.
If the dryer is in the Level 2 state, the indicator blinks for 3 hours after the completion of the current
cycle. If you press Power or open the door, the dryer powers off immediately.
NOTE
• For duct installation, see “Exhaust ducting guide”.
• The dryer may keep running even if the duct is clogged, but the drying time will be extended.
• If the indicator turns on for the first time and is solid (not blinking), check and clean the lint filter and/
or duct.
• If the indicator turns on again later, it is because the duct is installed or connected with some
restrictions (it’s too long or has too many bends). This is not a system failure. However, drying time may
be extended or the drying performance may be degraded.
Untitled-16 53 2022-08-02  6:08:49