User Manual
Table Of Contents
English 45
Troubleshooting
Problem Possible cause Solution
There are
food particles
remaining on
dishes.
(Not cleaning
properly.)
There is no rinse aid.
• Check the dispenser and add rinse
aid.
• Use liquid type rinse aid.
A nozzle is clogged. • Clean the nozzle. See page 38.
The dishes are
improperly loaded.
Too many dishes have
been loaded.
• Rearrange the dishes so they do not
interfere with nozzle rotation and
detergent dispenser operation.
• Load only an appropriate number of
dishes.
• Load your dishes as recommended.
(See page 16.)
• Load the heavily soiled items into the
Storm Wash area. (See page 17)
The lters are clogged or
not correctly fastened.
(Food soils remain on the
lter.)
• Scrape food from dishes prior to
loading. (Do not pre-rinse.)
• Clean the lter. (See page 39.)
• Make sure the lters are correctly
fastened.
Less water than required
is supplied.
• Check if the supplied water pressure
is between 20 and 120 psi (between
140 and 830 kPa).
Leaves glasses
with a light lm.
The water supplied is soft
and too much detergent
was used.
• Underload the dishwasher and use a
rinse aid to minimize this.
Aluminum dishes were
included in the wash
load.
• Remove the marks on the dishes
using a low sensitivity cleaner.
Leaves a yellow
or brown lm on
the inside of the
dishwasher.
This is caused by coffee
and tea soils.
• Remove the soils using a spot cleaner.
• Use a cycle with a higher
temperature.
DW7000B_DW80B7070_AA_DD68-00243A-00_EN.indd 45 2021-11-11 12:43:27