Installation Guide 2019.04.01

Installation
Installation
English10
If this is a new installation, follow these steps:
1. Using a 2
1
/2 inch hole saw, cut a hole into the side of the cabinet that holds the sink as
shown in Figure 1-1 below.
2. If the base inside the sink cabinet is raised above the kitchen oor and is higher than the
connections on the dishwasher, make a hole in the base inside the cabinet and in the cabinet
side as shown in Figure 1-2.
NOTE
Depending on where your electrical outlet is, you may need to cut a hole in the opposite
cabinet side.
Figure 1-1
The hole for the water supply line, drain
hose and power cables.
Figure 1-2
CAUTION
Make sure the cabinet hole is smoothened before you insert the drain hose through the
hole. A sharp edge of the cabinet hole may cause damage to the drain hose, resulting in a
leak of the hose.
DW9900R_DD68-00208B-00_EN.indd 10 12/29/2018 1:57:41 PM