Specifications

2
STEP 3 PUTTING THE PAPER IN THE PRINTER
STEP 3.1 LOADING THE DETAIL PRINTER
( 1 ) Plug the cash register’ s power cord into the properly grounded wall socket.
( 2 ) Place the key marked ‘ REG’ into the control lock and turn to the “ REG” position.
( 3 ) Locate the black plastic rewind spindle in the Styrofoam.
( 4 ) As you face the keyboard, notice two plastic trays at the bottom of the printer compartment.
Place one of the paper rolls into the tray on the right.
Make sure the paper will unwind from the bottom of the roll.
( 5 ) Fold back about 6 inches of paper and insert the folded end of the tape into the feed slot
just in front of the paper tray at the rear of the printer.
( 6 ) Press the “ DETAIL FEED” key on the keyboard until the edge has fed through the printer.
Run 6 ~ 8 inches of paper through the printer.
( 7 ) Hold the black rewind spindle with the gear to the right and the shaft to the left.
Insert the end of the paper into the slot on the shaft of the rewind spindle.
Wind the spindle several times to be sure that the paper will stay on the spindle.
( 8 ) Slide the axle of the rewind spindle ( between the gear and the shaft ) into the notch of the
printer housing.
( 9 ) Press the “ DETAIL FEED” key several times again to make sure that the paper moves properly
through the printer.
* LOADING DETAIL PAPER * * LOADING RECEIPT PAPER *
NOTE : The socket-outlet shall be near the equipment and it shall be easy accessible.