ADT Motion Detector Setup Guide
A 1. 2. Setup Take the ADT Motion Detector to where you intend to mount it after setup. • Make sure you are within 350 feet from the ADT Security Hub. (Exact range depends on your home’s construction, the environment, the position of the ADT Security Hub, and the position and number of other connected devices.) • Make sure that your ADT Security Hub is disarmed before connecting a new device. • Make sure that you only setup one new device at a time.
Setup Setup 4. Use the SmartThings app to scan the QR code on the front of the detector and then follow the on-screen instructions to complete setup. QR Code Walk Test Button 5. Remove the QR code from the front of the detector and attach it inside the ADT Security Hub User Guide for future reference.
B Placement Place the ADT Motion Detector in a high-traffic area where an intruder would be likely to pass within a 30-foot range, e.g. living room or hallway. • Make sure that there are no objects blocking the detector's view and that it's in a stable location. • Make sure you do not aim the detector at stairs, furniture, or other surfaces that a pet might climb on. • Make sure that you do not place the detector in a room where large pets (over 55 lbs) may be present and could cause false alarms.
C 1. Mounting Mounting Pick a location 6.5 to 7.5 feet above the floor and mount the detector on a flat wall or in a corner. Corner Mount Wall Mount Bracket 2. Adjust the angle of the detector using a screwdriver. Adjust With Screwdriver Flat Wall Mount You can also use the supplied mounting tape if you do not want to use the wall bracket.
D Testing You can test the coverage of the ADT Motion Detector by pressing the Walk Test button on the side. For the next 10 minutes, the red LED will illuminate when it senses movement, allowing you to adjust the aim of the detector to cover the desired protection area. Note that each time the red LED illuminates, a signal will be sent to the ADT Security Hub.
Suggestions There are many ways you can use an ADT Motion Detector in your home: • Put one in your hallway or near your back door and set it to initiate optional ADT professional monitoring services if an intrusion is detected in your home (additional fees apply). • Put one in your basement and set it to send you a message if unexpected activity is detected. • Put one in your hallway and set it to turn on connected lights when motion is detected.
F Works With SmartThings SmartThings works with a wide range of connected devices, including lights, cameras, locks, thermostats, and sensors. It also works with the Google Assistant and Amazon Alexa so you can control your smart home with voice commands. Look for the Works with SmartThings label next time you’re buying a connected device for your home, or visit SmartThings.com to see the full list of compatible devices.
SmartThings, Inc., 665 Clyde Ave, Mountain View, CA 94043, USA. Information in this document is subject to change without notice. Copyright 2017 SmartThings, Inc. All rights reserved. ADT and the ADT logo are marks and/or registered marks of ADT. Unauthorized use is strictly prohibited. Revised 06/17. P/N 10015709.