User Manual

Adjusting the leveling feet
If the floor is uneven, adjust the feet (do not insert pieces of wood or
any other objects under the feet):
1. Loosen the leg bolt by turning it with your hand until it is at the
desired height.
2. Tighten the locking nut by turning it with the supplied wrench.
• Place the washer on a sturdy, flat surface.
If the washer is placed on an uneven or weak surface, noise or
vibration occurs. (Only a l degrees angle is allowed.)
Removing the shipping bolts
Before using the washing machine, you must remove the five shipping
bolts from the back of the unit. To remove the bolts:
1. Loosen all bolts with the supplied wrench before removing them.
2. Take each bolt head and pull it through the wide part of the hole.
Repeat for each bolt.
3. Fill the holes with the supplied plastic covers.
4. Keep the shipping bolts for future use.
Connecting the water supply hose(Option)
Installing the Washing Machine
3
a
b
c
1. Remove the adaptor from the water supply
hose.
2. First, using a “+” type screw driver, loosen the
four screws on the adaptor. Next, take the
adaptor and turn part(b) following the arrow until
there is a 5mm gap.
3. Connect adaptor to the water tap by tightening
the screws firmly. Then, turn part (b) following
the arrow and put(a) and (b) together.
4. Connect the water supply hose to the adaptor.
Pull down part (c) of the water supply hose.
When you release part (c) the hose
automatically connects to the adaptor making a
’click’ sound.
5. Connect the other end of the water supply hose
to the inlet water valve at the top of the washer.
Screw the hose clockwise all the way in.
• If the water tap has a screw type faucet,
connect the water supply hose to the tap as
shown.
NOTICE : After completing connection, if water leaks from the hose, then
repeat the same steps. Use the most conventional type of faucet
for water supply. In case the faucet is square or too big, remove
the spacing ring before inserting the faucet into the adaptor.