Owers Guide

Installation
Installation
English28
BA
To connect the water hoses to the taps:
1. Connect one end of each water hose to
the Hot or Cold tap.
2. Turn the ttings by hand until they
are tight, and then tighten them an
additional two-thirds of a turn with
a pliers. To prevent damage, do not
overtighten the ttings.
3. When done, pull the water hoses up
and down to check if they are properly
connected.
4. Put the other ends of the hoses into
a bucket and open the taps for 10-15
seconds to remove impurities. When
done, close the taps.
FlexWash_WV9900M_DC68-03768A-07_EN.indd 28 2019-02-20  11:06:58