Owner's Manual
Installation
Installation
English28
BA
To connect the water hoses to the taps:
1. Connect one end of each water hose to
the Hot or Cold tap.
2. Turn the ttings by hand until they
are tight, and then tighten them an
additional two-thirds of a turn with
a pliers. To prevent damage, do not
overtighten the ttings.
3. When done, pull the water hoses up
and down to check if they are properly
connected.
4. Put the other ends of the hoses into
a bucket and open the taps for 10-15
seconds to remove impurities. When
done, close the taps.
FlexWash_WV9900M-03768A-02_EN+CFR+MES.indb 28 2/8/2017 8:02:04 PM