Installation and User Manual GN641FFBD GN641FFXD GN641FFWD GN642FFBD GN642FFXD GN642FFWD Built-In Hotplate GB
Content Preface.......................................................3 Safety Warning ........................................4-9 - Safety Warning ..........................................4 - Installation .................................................5 - Child and People Safety ............................6 - During Use ............................................ 7-8 - Cleaning & Service ....................................9 - Environmental Information ........................
Preface Thank you for using our appliance. To use this appliance correctly and prevent any potential risk, read these instructions before use the appliance. Keep these instructions at the place where you can find it easily. If you are unsure of any of the information contained in these instructions, please contact the SamSung customer care center. These instructions are only valid for the countries of destination, the identification symbols which are indicated on the cover of the instruction manual.
Safety Warning ■ Your safety is the utmost importance to SamSung. ■ You must read warnings carefully before installing or using the appliance. ■ This instruction booklet must be kept with the appliance for any future reference. If the appliance is sold or transferred to another person, ensure the booklet is passed on to the new user. ■ The manufacturer declines any liability should these safety measures not be observed.
Installation Warning ■ This appliance shall be installed in accordance with regulations in force and only used in a well ventilated space. ■ Prior to installation, ensure that the gas and electrical supply complies with the type stated on the rating plate. G30,G31 G20 ■ Do not install this appliance on any type of marine vessel or Leisure Accommodation Vehicle. 220V 110V ■ The gas pipe and electrical cable must be installed in such a way that they do not touch any parts or the appliance.
Child and People Safety Warning ■ Do not allow children to play near or with the appliance. The appliance gets hot when it is in use. Children should be kept away until it has cooled. Caution ■ This appliance is designed to be operated by adults. ■ Children can also injure themselves by pulling pans or pots off the appliance.
During Use Warning ■ Only use the appliance for preparing food. Never use it as a heater. ■ It is dangerous to modify or try to modify the characteristics of this appliance. ■ The use of a gas cooking appliance results in the production of heat and moisture in the room in which it is installed. Ensure that the kitchen is well ventilated : keep natural ventilation holes open or install a mechanical ventilation device (mechanical extractor hood). ■ Do not use this appliance if it is in contact with water.
During Use (Continued) ■ Do not place any flammable object near the appliance. ■ Perishable food, plastic items and aerosols may be affected by heat and should not stored above or below the appliance. ■ Do not spray aerosols in the vicinity of this appliance while it is in operaiton. ■ Ensure the control knobs are in the ‘OFF’ position when not in use. Caution ■ This appliance is intended for domestic cooking only. It is not designed for commercial or industrial purposes.
Cleaning & Service Warning ■ Never use abrasive or caustic cleaning agents. ■ This appliance should only be repaired or serviced by an authorised Service Engineer and only genuine approved spare parts should be used. Caution ■ Before attempting to clean the appliance, it should be disconnected from the mains and cool. ■ You should not use a steam jet or any other high pressure cleaning equipment to clean the appliance.
Description of the appliance 4 2 3 3 9 1 5 10 6 7 8 7. Control handle for front right burner (Semi-rapid burner) 8. Control handle for rear right burner (Semi-rapid burner) 9. Pan support 10. Connection Cord 1. Top Plate 2. Auxiliary Burner 3. Semi-rapid Burner 4. Rapid Burner 5. Control handle for rear left burner (Rapid burner) 6. Control handle for front left burner (Auxiliary burner) Burner Handle 11 12 13 (Auxiliary, Semi-rapid and Rapid) 11. Control handle 12. Sealing ring 13.
How to Use the Appliance Turn on 1 Preparation The following symbols will appear on the control panel, next to each control handle : Circle : gas off Small flame : minimum setting Large flame : maximum setting Ignition position ■ The minimum setting is at the end of the anti-clockwise rotation of the control handle. ■ All operation positions must be selected between the maximum and minimum position. ■ The symbol on the control panel, next to the control handle will indicate which burner it operates.
How to Use the Appliance (Continued) Turn off 3 Extinguishment ■ Turn the control handle to clockwise, to setting ‘O’ (off position) ■ Close the middle valve. ■ Right after extinguishment, the appliance is still hot. Be careful not to be burned. ■ This appliance is fitted with a Flame supervision device which cuts off the supply of gas to a burner if the flame goes out, for example if food has boiled over, or if there was a sudden draught.
Safety and Energy saving advice - The diameter of the bottom of the pan should correspond to that of the burner. BURNERS Rapid Semi-Rapid Auxiliary PANS Φ min. 200mm 130mm 100mm ■ User can’t use cooking pan on the hotplate that overlap its edge. Φ max. 260mm 180mm 120mm NO YES Do not use small diameter cookware on large burners. The flame should never come up the sides of the cookware. Always use cookware that are suitable for each burner, so as to avoid wasting gas and discolouring the cookware.
Cleaning and Maintenance ■ Cleaning operations must only be carried out when the appliance is cool. ■ The appliance should be disconnected from your mains supply before commencing any cleaning process. ■ Clean the appliance regularly, preferably after each use. ■ Abrasive cleaners or sharp objects will damage the appliance surface;you should clean it using water and a little washing up liquid.
Cleaning and Maintenance (Continued) BURNERS ■ Remove the burner lids and Flame Spreaders by pulling them upwards and away from the top plate. ■ Soak them in hot water and a little detergent. ■ After cleaning and washing them, wipe and dry them carefully. Make sure that the flame holes are clean and completely dry. ■ Wipe the fixed parts of the burner cup with a damp cloth and dry afterwards.
Troubleshooting ■ Repairs to the gas and electrical components of this appliance must only be carried out by a suitably qualified and competent person to ensure safety. ■ However, some minor problems can be resolved as follows : Problem Probable cause Solution No Spark. Check the electricity supply The burner lid is badly assembled. Assemble the lid correctly. The middle valve is closed. Open the middle valve completely. The middle valve is incompletely opened. Open the middle valve completely.
Application for Service If you have any comments or questions regarding a Samsung products, contact the SAMSUNG customer care center. Region Country Customer Care Center (TEL) BELGIUM 02 201 2418 CZECH REPUBLIC 844 000 844 DENMARK 70 70 19 70 FINLAND 030-6227 515 FRANCE GERMANY Web Site FAX no. Address www. samsung.be www. samsung.com/cz www. samsung.com/dk www. samsung.com/fi N/A Samsung Electronics Benelux B.V.
Technical instructions ■ This appliance must be installed by a qualified technician or installer. ■ Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure) and the adjustment of the appliance are compatible. ■ The adjustment conditions for this appliance are stated on the label (or data plate). ■ This appliance is not connected to a combustion products evacuation device. It shall be installed and connected in accordance with current installation regulations.
Engineers technical data Appliance Specification D D H H W W Model GN641FFXD GN641FFBD GN641FFWD GN642FFXD GN642FFBD GN642FFWD Drawing Pan Support Top Plate Control Handle Cast Iron Stainless steel Black enamel White enamel Stainless steel Black enamel White enamel Silver color Titan color White color Silver color Titan color Weight (net) 7.5kg 9kg Weight (gross) 9.
Positioning CLEARANCES REQUIRED WHEN FITTING THE HOB WITHOUT A COOKER HOOD ABOVE CLEARANCES REQUIRED WHEN FITTING THE HOB WITH A COOKER HOOD ABOVE 600 mm 700 mm 700 mm 400 mm 55 55 m m m m 400 mm m 560 mm m m 400 mm 100 m 49 0 m 0 mm 49 560 m 400 mm 100 m m Cut out size Width : 560mm Depth : 490mm Thickness : 30~50mm FO 0813 FO 0812 ■ This appliance is to be built into a kitchen unit or 600mm worktop, providing the following minimum distances are allowed ; - The edge of the appliance
Installing the appliance 1. Remove the pan support, the burner lid and flame spreader and carefully turn the appliance upside down and place it on a cushioned mat. Take care that the Ignition devices and flame supervision devices are not damaged in this operation. 2. Apply the sealing strip provided around the edge of the appliance. 3. Do not leave a gap in the sealing agent or overlap the thickness. Do not use a silicon sealant to seal the appliance against the aperture.
Gas Connection ■ This appliance must be installed and connected in accordance with installation regulations in force in the country in which the appliance is to be used. ■ This appliance is supplied to run on natural gas only and cannot be used on any other type of gas without modification. Conversion for use on LPG and other gases must only be undertaken by a qualified person. The gas inlet connection fitting is 1/2 inch female thread.
Electrical Connection ■ This appliance must be earthed. ■ This appliance is designed to be connected to a 220~240V, 50/60Hz AC electricity supply. ■ The wires in the mains lead are coloured in accordance with the following code ; - Green/yellow = Earth - Blue = Neutral - Brown = Live ■ The wire which is coloured green and yellow must be connected to the terminal which is marked with the letter E or by the earth symbol.
Gas Conversion 1 2 ■ Be careful, the operations and adjustments to be carried out when converting from one gas to another. ■ All work must be carried out by a qualified technician. ■ Before you begin, turn off the gas and electricity supply to the appliance. Change the injector of the burners. Remove the pan support, Burner lid and Flame spreader. Injector Unscrew the injector using a 7mm box spanner and replace it with the stipulated injector for new gas supply. ( see table 1. Page 25.
Burner Features (Table 1) Nominal heat input and flow rates see below at 15˚C at 1,013 mbar. COUNTRY GB,IT FR,HU BE,LT NL,PT ES,CZ SK PL GB,IT FR,BE LT,PT ES,CZ SK BURNER TYPE OF GAS POSITION Rapid Max Injector make (1/100 mm) G-30 BUTANE 29 mbar G-31 PROPANE 37 mbar GB,IT FR,BE LT,PT PL,ES CZ,SK G-20 NATURAL 20 mbar HU G-20 NATURAL 25 mbar Max 85 Min Auxiliary Max 65 Min 50 3.0 0.78 1.75 0.49 1.0 0.4 Nominal flow rates (g/h) 216 53 125 33 74 28 80 62 47 3.0 0.88 1.
MEMO 26
GB
