User manual

18 English
Connections
English 19
Connect the Stand Pole to the Stand Bracket.
Insert and tighten three large screws (5*15, For
connecting Stand Pole & Stand Bracket) into the
three holes on the Stand Bracket as shown in the
illustration.
1.
2.
Straighten the speaker wire and route it through
the Stand Pole.
3.
Connect the Stand Pole to the Stand Neck and
Stand Base.
- Make sure all holes are properly connected,
if not, the stand will fall down.
4.

Installing the Speakers on the Tallboy Stand
* HT-C755W
* Front/Rear Speakers only
Insert and tighten three large screws (5*15, For
connecting Stand Pole & Stand Base) into the
three holes on the bottom side of the stand-base
as shown in the illustration.
CAUTION : When you use a torque
screwdriver, be careful not to put excessive
force. Otherwise, it runs idle or can be
damaged. (torque screwdriver- below 15
kg.f.cm
Connect the speaker wire to the speaker jack.
5.
!
6.
Fully insert the Stand Bracket into the speaker's
clasp to stand speaker.
Insert and tighten two small screws (4*20, For
connecting Stand Bracket & Speaker) into the two
holes to connect them.
This is the appearance after the speaker is installed.
Follow this steps to install other speaker.
7.
8.
9.
Stand Pole
Stand Bracket
 

Stand Pole
Stand Base
Stand Neck



 
This is the appearance after the speaker is installed.
