User manual
20 English
English 21
03 Setup
Settings
Move Select Return
Speaker Setting
Speaker Size ▶
Sound Edit
Delay Time
T
est Tone : Off
Select Return
For the Front, the mode is set to Small.
For the Subwoofer, the mode is set to Present.
For the Center and Surround, you can switch the
mode to Small or None.
- Small : Select this when using the speakers.
- None :
Select this when no speaker is
connected.
NOTE
The speaker mode may vary depending on the
Dolby Pro Logic and Stereo settings.
Sound Edit
You can adjust the balance and level for each speaker.
Settings
m
Move
"
Select
'
Return
Sound Edit
<
Change
"
Select
'
Return
dB
dB
dB
dB
dB
dB
dB
Front Bal.
Surround
Bal.
Center Level
Surround Level
SW Level
R
R
L
L
Press the
$%
buttons to select and adjust the
desired speaker.
Press the
_+
buttons to adjust the settings.
Adjusting Front/Surround Bal.
You can select between 0 and -6.
The volume decreases as you move closer to –6.
Adjusting Center/Surround/Subwoofer Level
The volume level can be adjusted in steps from
+6dB to –6dB.
The sound gets louder as you move closer to +6dB
and quieter as you get closer to -6dB.
~
~
~
✎
`
`
`
`
`
Delay Time
If the speakers cannot be placed at equal distances from
the listening position, you can adjust the delay time of the
audio signals from the Center and Surround speakers.
You can also set the Test Tone in this mode.
Setting up the Speaker Delay Time
When 5.1CH Surround Sound is played, you can
enjoy the best sound if the distance between you
and each speaker is the same.
Since the sounds arrive at the listening position at
different times depending on the placement of
speakers, you can adjust this difference by adding a
delay effect to the Center and Surround Speakers.
Settings
m
Move
"
Select
'
Return
<
Change
"
Select
'
Return
Delay Time
Front
Center : 00ms
Surround :
10ms
Subwoofer
Test Tone :
Off
Test Tone
Settings
m
Move
"
Select
'
Return
Speaker Setting
Speaker Size
Sound Edit
Delay Time
Test Tone :
On ▶
"
Select
'
Return
Use the Test Tone feature to check the speaker
connections.
Press the
_+
buttons to select On.
The test tone will be sent to Front Left ➞ Center
➞ Front Right ➞ Surround Right ➞ Surround
Left ➞ Subwoofer in order.
To stop the test tone, press the ENTER button.
~
~