Use and Care Manual

 - English
Connections
Connecting to a TV and External Devices
OPTICAL OUT
AUDIO OUT
HDMI IN
 
R

W



Connect an HDMI cable (not supplied) from the HDMI OUT jack on the back of the product to the HDMI IN
jack on your TV. If the TV supports ARC, you can hear the audio from your TV through the home theater with
only this cable connected. See page 17 in this manual and the section on ARC in your TV's user's manual
for details.

Two methods of connecting external devices to your home theater are explained below.

Using an RCA audio cable (not supplied), connect the AUDIO In jack on the product to the AUDIO Out jack on
the external analog component.

Select the  mode.

Be sure to match the colors on the cable plugs to the colors on the input and output jacks.

Use to connect the digital audio output of digital signal components such as Cable Boxes and Satellite
Receivers (Set-Top-Boxes) to the home theater. Using a digital optical cable (not supplied), connect the Optical
Digital Audio In jack on the product to the Digital Optical Out jack of the external digital device using a digital
optical cable.

Select the  mode.
✎
To see video from your Cable Box/Satellite receiver, you must connect its video output directly to your TV.
✎
This system supports Digital sampling frequencies of 32 kHz or higher from external digital
components.
✎
This system supports only DTS and Dolby Digital audio. MPEG audio, a bitstream format, is not
supported.

To select an external device after you have connected it, press the  button. Each time you press the
button, the mode changes in this order : 
;

;

;

;
