Use and Care Manual

 - English

Network Setup
When you connect this product to a network, you
can use network based applications and functions
such as BD-LIVE and upgrade the product's software
through the network connection.

To begin configuring your network connection,
follow these steps:
 In the Home screen, select , and then
press the
v
button.
 Select , and then press the
v
button.
 Select , and then press the
v
button.
 Go to the instructions for Wired networks
starting below or the instructions for Wireless
networks on the bottom right of this page.

Ğ

After following Steps 1 to 3 above:
 In the  screen, change
 to . Then, select 
and press the
v
button. The product detects
the wired connection, verifies the network
connection, and then connects to the network.
 When it is done, highlight , and then press
v
button.
Ğ

If you have a static IP address or the automatic
procedure does not work, you'll need to set the
 values manually.
After following Steps 1 to 3 above:
 In the  screen, change
 to . Then, select 
and press the
v
button.
The product searches for a network, and then
displays the connection failed message.
✎
If it is possible to connect the home theater
to your network wirelessly, select 
 at this point, change the 
 to , and then go to the
instructions for wireless networks on the
bottom right of this page.
Network Settings
MAC Address XX:XX:XX:XX:XX:XX
IP Address 0. 0. 0. 0
Subnet Mask 0. 0. 0. 0
Gateway 0. 0. 0. 0
DNS Server 0. 0. 0. 0
a Previous d Skip < Move " Select
IP auto setting failed. Try the following to set up IP automatically, or set up the IP manually by
selecting 'IP Settings'.
- Ensure that DHCP server is enabled on the wireless network, and then unplug and re-plug the wireless
network.
- Contact your Internet Service Provider for more information.
Wired network connection failed.
Change Network
IP Settings Retry Close
 Use the ◀▶ buttons to select , and
then press the
v
button. The 
screen appears.
 Select the  field, and then set it to
.
 Select a parameter to enter (, for
example), and then press
v
. Use the number
keypad on your remote control to enter the
numbers for the parameter. You can also enter
numbers using the ▲▼ buttons. Use the ◀▶
buttons on the remote control to move from
entry field to entry field within a parameter.
When done with one parameter, press the
v
button.
 Press the ▲ or ▼ button to move to another
parameter, and then enter the numbers for that
parameter following the instructions in Step 4.
 Repeat Steps 4 and 5 until you have filled in all
parameters.
✎
You can get the network parameter values
from your Internet provider.

When finished entering all the parameter
values, select  (
'
), and then press the
v
button. The home theater verifies the
network connection and then connects to the
network.

You can set up a wireless network connection in
three ways:
-
Wireless Automatic
-
Wireless Manual
-
WPS(PBC)
Before you configure the wireless network
connection, disconnect any wireless network devices
currently connected to the product or, if applicable,
the product's current wired connection.