User manual

 - English

Network Setup
When you connect this product to a network,
you can use network based applications and
functions such as Smart Hub and BD-LIVE, and
upgrade the product's software through the
network connection. For more information about
accessing and using Internet services, see the
Network Services chapter of this manual on pages
43~50. Instructions for configuring the
network connection start below.

If you didn't configure your network connection
during the initial settings procedure or you need
to reset the network connection, follow the
directions below.
Before you begin, contact your Internet Service
Provider to find out if your IP address is static or
dynamic. If it is dynamic, and you have a wired
or wireless network, we recommend using the
Automatic configuration procedures described
below.
If you are connecting to a wired network, connect
the product to your router using a LAN cable
before you start the configuration procedure.
To begin configuring your network connection,
follow these steps:
 In the Home screen, select , and then
press the  button.
 Select , and then press the 
button.
 Select , and then press the
 button.
 Go to the instructions for Wired networks
starting or the instructions for Wireless
networks starting on the next page.

Ğ

After following Steps 1 to 3 above:
 In the  screen, change
 to . Then, select 
and press the  button. The product
detects the wired connection, verifies the
network connection, and then connects to
the network.
 When it is done, highlight , and then
press  button.
Ğ

If you have a static IP address or the automatic
procedure does not work, you'll need to set the
 values manually.
After following Steps 1 to 3 above:
 In the  screen, change
 to . Then, select 
and press the  button.
The product searches for a network, and
then displays the connection failed message.
✎
If it is possible to connect the home cinema
to your network wirelessly, select 
 at this point, change the 
 to , and then go to the
instructions for wireless networks on the next
page.


 
 
 
 
 


   
 Use the
:;
buttons to select ,
and then press the  button. The 
screen appears.
 Select the  field, and then set it to
.
 Select a parameter to enter (, for
example), and then press . Use the
78
buttons on the remote control to enter the
numbers for the parameter.
Or use the Num
keypad to enter a parameter number.
Press and
hold the  button until the Num pad appears
on the screen. When the Num pad appears,
select a number using the
78:;
button
and then press the
 button. Use the
:;
buttons on the remote control to move from
entry field to entry field within a parameter.
When done with one parameter, press the
 button.
 Press the
7
or
8
button to move to another
parameter, and then enter the numbers for
that parameter following the instructions in
Step 4.