User Manual

ENG - 14
Manually connecting the Wireless Surround speaker if automatic connection fails
Before performing the manual connection procedure below:
• Check whether the power cables for the Soundbar and Wireless Surround speaker are
connected properly.
• Make sure that the Soundbar is turned on.
1. Press the ID SET button on the back of the Wireless Receiver Module with a pen tip for 5~6 seconds
until the LINK LED indicator blinks fast (in Blue).
ID SET
L R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
POWER
POWER
ID SET
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
STANDBY
LINK
STANDBY
LINK
Blue blinking
5 Sec
2. Press and hold the button on the remote control for at least 5 seconds.
B G
Blue and Green
alternately blink X 3
5 Sec
3. Check if the LINK LED is solid blue (connection complete)
STANDBY
LINK
STANDBY
LINK
Blue is On
The LINK LED indicator stops blinking and
glows a solid blue when a connection is
established between the Soundbar and the
Wireless Receiver Module.