User Manual

ENG - 41
Update Procedure
Important: The update function erases all user
settings. We recommend you write down your
settings so that you can easily reset them after
the update.
1. Connect a USB thumb drive to the USB port
on your computer.
Important: Make sure there are no music
les on the USB thumb drive. This may cause
the rmware update to fail.
2. Go to https://www.samsung.com/us/
support/downloads/ on your computer 
select Enter Model Number and enter the
model of your Soundbar. Select manuals and
downloads and download the latest software
le.
3. Save the downloaded software to a USB
stick and select “Extract Here” to unzip the
folder.
4. Turn off the Soundbar and connect the USB
stick containing the software update to the
USB port.
5. Disconnect the power cord, reconnect it, and
then turn on the Soundbar.
6. Turn on the Soundbar and select mode to
USB. Within 3 minutes, 4 white LEDs on and
update begins.
7. When the update complete, the Soundbar
turns restart. Press and hold both and
(Volume) button on the right panel for 5
seconds.
All LEDs blink 4 times and then the Soundbar
turns on. The update is complete.
• If the rmware fails to update, you can
update the rmware again.
8. Restore your settings on the Soundbar.
When update fails
1. Turn off the Soundbar, disconnect and then
reconnect the USB storage device that
contains the update les to the Soundbar’s
USB port.
2. Disconnect the Soundbar’s power cord,
reconnect it, and then turn on the Soundbar.
NOTES
– The rmware update may not work properly
if audio les supported by the Soundbar are
stored in the USB storage device.
– Do not disconnect the power or remove the
USB device while updates are being applied.
The main unit will turn off automatically after
completing the rmware update.
– After the update is completed, the user setup
in the Soundbar is initialized so you can reset
your settings. We recommend you write
down your settings so that you can easily
reset them after the update. If the software
update fails, check if the USB stick is
defective.
– Mac OS users should use MS-DOS (FAT) as the
USB format.
– Updating via USB may not be available,
depending on the USB storage device
manufacturer.