User Manual
14
You can enjoy ner quality of music through the speaker by sending iPod/iPhone’s audio signal using a
Wireless Transmitter.
To link the main unit with wireless transmitter, you have to make ID setting when both main unit and wireless
transmitter are standby.
Turn on the main unit and connect the iPod/iPhone to the Wireless transmitter.
Then press button on the remote control to select "W iPod" mode.
The mode of the main unit will switches as follows.
Repeatedly press DIGI.1
➡
DIGI.2
➡
ANALOG
➡
W iPod
➡
HDMI.1
➡
HDMI.2
( See page 20 )
The Sound bar will not be turned off if iPod/iPhone is not connected to the Wireless Transmitter.
For more information on HT-WDC10, refer to the HT-WDC10’s user manual.
Power on /Charging completed
Charging.
Connect the Wireless Transmitter to the Charging
Cradle.
Connect the DC power adaptor to a wall socket.
The charging indicator lights up and charging starts.
After the battery is fully charged, the charging
indicator turns Green.
•
STANDBY
LINK
CHARGE
The indication is the charging state of the built-in battery in iPod main Dock.
Check the charging state of iPod/iPhone by checking the charging indication of its battery.
▪
▪
CHARGE
STANDBY
LINK
“Made for iPod,” and “Made for iPhone” mean that an electronic
accessory has been designed to connect speci cally to iPod or
iPhone, respectively, and has been certi ed by the developer to
meet Apple performance standards. Apple is not responsible for the operation of this device or
its compliance with safety and regulatory standards. Please note that the use of this accessory
with iPod or iPhone may affect wireless performance.
iPhone, iPod, iPod classic, iPod nano, and iPod touch are trademarks of Apple Inc., registered
in the U.S. and other countries.
The volume control may not be operated normally except at the referred models. If there is any error
happened at the models above, please update the software of iPod/iPhone at the lastest version.
▪
▪
▪