Manual

functions
Using the Anynet+(HDMIoCEC) function
Anynet+ iets you control other Samsung Devices with your Samsung TV's
remote contro _
The Anynet+ function turns on and off each time you press Anynet+_
!_ Connect the product to a Samsung TV with an HDMI cable_
(See page i3)
2_ Set the Anynet+ function on your TV and the Soundbar to ON_ (See
the TV instruction manual for more information,)
o os_st
_'_,,M{,,_, _,;;_,_...................
'_ Depending on yourTV certain HDMI output resolutions may not
work_
'_ Pease refer to the user's manua of your %/and check for the _t_y_t:
ogo (If your TV has an _/I;;y_ ogo, then it supports the Anynet+
function)
Using the TV functions (with Samsung TVs only}
PressTv' SOURCEon the remote control to change the TV's input source
Press_ INFO on the remote control to display the TV channel information
PressW CH on the remote contro to seect the TV channe _
PressW VOL on the remote contro to increase or decrease the voume eve_
Use W PREoCHbutton to move to the previous TV channe in TV mode_
To exit the TV menu, use the W EXIT button_ (It functions the same as the
EXIT button of the TV remote contro _)
When you press the SoundConnect button, the ]V's sound is
transmitted through the Soundbar system via a Bluetooth
connection_ The Soundbar also controls the sound volume, sound
quality, etc_
The remote control can operate TVs made by SAMSUNG only_
SOFTWARE UPGRADE
Samsung may offer upgrades for the Wiretess Audio o Soundbar's system
firmware in the future
tf an upgrade isoffered, you can upgrade the firmware by connecting a USB
drive with the firmware upgrade stored on it to the USBport on your
Soundbar
Note that if there are multiple upgrade files, you must load them onto the
USBdrive singly and use them to upgrade the firmware one at a time
Pleasevisit Samsung corn or contact the Samsung call center to receive
more information about downloading upgrade files
22
'_' insert a USBdrive containing the firmware upgrade into the USBport on the main uniL
'_' Do not disconnect the power or remove the USB drive while upgrades are being applied_ The main unit will turn off
automatically after completing the firmware upgrade_
When software is upgraded, settings you have made will return to their default (factor},])settings_
We recommend you write down },'our settings so that you can easily reset them after the upgrade_
'_' Once upgrading the product software iscompleted, turn off the product and then press and hold (m) button for a
while to reset the producL
'_' tf the firmware fails to upgrade, we recommend formatting the USBdevice in FAT16and trying again_
'_' Forupgrading purposes, do not format the USBdrive in NTFSformat because it is not a supported file system_
'_' Depending on the manufacturer, some USBdevices may not be supported_