Quick Guide
Table Of Contents
- 01 Checking the Components
- 02 Product Overview
- 03 Connecting the Soundbar
- 04 Connecting to your TV
- 05 Connecting an External Device
- 06 Connecting a USB Storage Device
- 07 Connecting a Mobile Device
- 08 Using the Remote Control
- 09 Installing the Wall Mount
- 10 Troubleshooting
- 11 License
- 12 Open Source License Notice
- 13 Important Notes About Service
- 14 Specifications and Guide
ENG - 7
3. Press and hold the VOL button on the remote control for at least 5 seconds.
• The ID SET message appears on the display of the Soundbar for a moment, and then it
disappears.
Surround
SOUND
MODE
Bluetooth
POWER
VOL
WOOFER
SOUNDBAR
5 Sec
ID SET
4. While the subwoofer’s indicator is blinking blue, press the (Power) button on your remote
control or on the right side of the main unit to turn on the main unit.
5. The connection is complete if the indicator on the rear of the subwoofer stops blinking and glows
continuously.
• If the connection process fails, the blue indicator will ash continuously. Go back to Step 1 and
start again.
Connecting the SWA-8500S to a Soundbar
(Only HW-MM37 supplied)
Expand to true wireless surround sound by connecting the Samsung Wireless Rear Speaker Kit
(SWA-8500S) to your Soundbar.
1. Connect the Wireless Receiver Module to the two Surround Speakers.
– The speaker cables are color coded.
SURROUND-LEFT
ID SET
L
R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
POWER
ID SET
L
R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
SURROUND-RIGHT
SURROUND-LEFT SURROUND-RIGHT
• When connecting the speaker cables to the Wireless Receiver Module, follow these steps:
1. Insert the grey plug into the grey jack on the Wireless Receiver.
2. Insert the blue plug into the blue jack on the Wireless Receiver.