Quick Guide
Table Of Contents
- 01 Checking the Components
- 02 Product Overview
- 03 Connecting the Soundbar
- 04 Connecting to your TV
- 05 Connecting an External Device
- 06 Connecting a USB Storage Device
- 07 Connecting a Mobile Device
- 08 Using the Remote Control
- 09 Installing the Wall Mount
- 10 Troubleshooting
- 11 License
- 12 Open Source License Notice
- 13 Important Notes About Service
- 14 Specifications and Guide
ENG - 9
6. Turn on the Soundbar using the Soundbar’s remote control or by pressing the (Power) button on
the main Soundbar unit.
ON
7. Check if the LINK LED is solid blue (connection complete)
STANDBY
LINK
STANDBY
LINK
Blue is On
The LINK LED indicator stops blinking and
glows a solid blue when a connection is
established between the Soundbar and the
Wireless Receiver Module.
8. If the SWA-8500S does not connect, take the necessary steps according to the LED Indicator’s
status.
LED status Action
LINK (Blue)
On
Connected with
the Soundbar
-
Blinking
Connection
standby status
Check if the Soundbar is turned on
Repeat steps 3 through 6.
STANDBY
(Red)
On
Connection
failure
Check if the Soundbar is turned on
1. Press the ID SET button on the back of the Wireless
Receiver Module with a pen tip for
5~6 seconds until the LINK LED indicator blinks (in
Blue).
ID SET
L
R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
POWER
ID SET
5 Sec
2. Repeat steps 3 through 6.
Others - Errors Contact a Samsung Service Center.