Owners manual
Table Of Contents
- HW-N450_ENG
- 01 Checking the Components
- 02 Product Overview
- 03 Connecting the Soundbar
- 04 Connecting to your TV
- 05 Connecting an External Device
- 06 Connecting a USB Storage Device
- 07 Connecting a Mobile Device
- 08 Using the Remote Control
- 09 Installing the Wall Mount
- 10 Software Update
- 11 Troubleshooting
- 12 License
- 13 Open Source License Notice
- 14 Important Notes About Service
- 15 Specifications and Guide
- HW-N450_FRA
- 01 Vérification des Composants
- 02 Présentation du Produit
- 03 Branchement du Soundbar
- 04 Branchement à votre Téléviseur
- 05 Branchement d’un Périphérique Externe
- 06 Connexion à un périphérique de stockage USB
- 07 Branchement d’un Appareil Mobile
- 08 Utlisation de la Télécommande
- 09 Installation du Support Mural
- 10 Mise à jour Logicielle
- 11 Dépannage
- 12 Licence
- 13 Avis de Licences Libres
- 14 Remarque Importante Concernant le Service
- 15 Caractéristiques et Guide
![](/manual/samsung/hw-n450-za/owners-manual-english/images/img-10.png)
ENG - 7
Manually connecting the Subwoofer if automatic connection fails
Before performing the manual connection procedure below:
• Check whether the power cables for the Soundbar and subwoofer are connected properly.
• Make sure that the Soundbar is turned on.
1. Press and hold ID SET on the rear of the subwoofer for at least 5 seconds.
• The red indicator on the rear of the subwoofer turns off and the blue indicator blinks.
5 Sec
Rear of Subwoofer
2. Press and hold the Up button on the remote control for at least 5 seconds.
• The ID SET message appears on the display of the Soundbar for a moment, and then it
disappears.
• The Soundbar will automatically power on when ID SET is complete.
ID SET
SOUND
MODE
PAIR
5 Sec
3. Check if the LINK LED is solid blue (connection complete).
Blue is On
The LINK LED indicator stops blinking and
glows a solid blue when a connection is
established between the Soundbar and the
Wireless Subwoofer.