User Manual
Table Of Contents
- Checking the Components
- Product Overview
- Using the Soundbar Remote Control
- Inserting Batteries before using the Remote Control (AAA batteries X 2)
- How to Use the Remote Control
- Active Voice Amplifier (AVA)
- Using the Hidden Buttons (Buttons with more than one function)
- Output specifications for the different sound effect modes
- Adjusting the Soundbar volume with a TV remote control
- Connecting the Soundbar
- Connecting to a TV
- Connecting an External Device
- Connecting a Mobile Device
- Connecting via Apple Airplay 2
- Installing the Wall Mount
- Installing the Soundbar in front of TV
- Software Update
- Troubleshooting
- License
- Open Source License Notice
- Important Notes About Service
- Specifications and Guide
ENG - 18
4. Check if the LINK LED is solid blue (connection complete)
STANDBY
LINK
STANDBY
LINK
Blue is On
The LINK LED indicator stops blinking and glows a solid blue when a connection
is established between the Soundbar and the Wireless Receiver Module.
5. If the SWA-9100 does not connect, take the necessary steps according to the LED Indicator’s status
LED status Action
LINK (Blue)
On Connected with the Soundbar -
Blinking Connection standby status
Check if the Soundbar is turned on
Repeat steps 3 through 4.
STANDBY (Red) On Connection failure
Check if the Soundbar is turned on
1. Press the ID SET button on the back of the Wireless
Receiver Module with a pen tip for 5~6 seconds until the
LINK LED indicator blinks (in Blue).
ID SET
L
R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
POWER
POWER
ID SET
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
5 Sec
2. Repeat steps 3 through 4.
Others - Errors Contact a Samsung Service Center.