User Manual
Table Of Contents
- Contents
- CONNECTING AND PREPARING YOUR TV
- Viewing the Control Panel
- Viewing the Connection Panel
- Viewing Pictures From External Sources
- Inserting the Batteries in the Remote Control
- Viewing the Remote Control (All Functions Except Teletext)
- Viewing the Remote Control (Teletext Functions)
- Switching On and Off
- Placing in Standby Mode
- Becoming Familiar with the Remote Control
- Plug & Play
- Selecting TV Mode or an Input Source
- Editing an Input Source Name
- SETTING THE CHANNELS
- SETTING THE PICTURE
- SETTING THE SOUND
- SETTING THE TIME
- USING THE VARIOUS FUNCTIONS
- USING THE TELETEXT FEATURE
- USING THE PC FUNCTIONS
- RECOMMENDATIONS FOR USE
- CONNECTING AND PREPARING YOUR TV
English-6
Viewing the Connection Panel
Connecting an Aerial or Cable Television Network (depending on the model).
To view television channels correctly, a signal must be received by the set from one of the
following sources:
- An outdoor aerial
- A cable television network
- A satellite network
Connecting Component Device (DVD - 480i, 480p, 576i, and 576p only supported).
- Connect component video cables to component connector (“Y”, “P
B
”, “P
R
”) on the rear of your set and the
other ends to corresponding component video out connectors on the DVD.
- The Y, Pb and Pr connectors on your component device (DVD) are sometimes labeled Y, B-Y and R-Y or Y,
Cb and Cr.
- Connect RCA audio cables to
“L - AUDIO - R” on the rear of your set and the other ends to corresponding
audio out connectors on the DVD.
- Input signals not supported: 720p, 1080i, and 1080p.
Connecting a Computer.
- Connect the 15 Pin D-SUB connector to the PC video connector.
- Connect the stereo audio cable to the “PC AUDIO IN” jack ( ) on the rear of your set and the other end to
the “Audio Out” jack of the sound card on your computer.
Pin Separate H/V Composite H/V
1 Red (R) Red (R)
2 Green (G) Green (G)
3 Blue (B) Blue (B)
4 Grounding Grounding
5 Grounding (DDC return) Grounding (DDC return)
6 Grounding - Red (R) Grounding - Red (R)
7 Grounding - Green (G) Grounding - Green (G)
8 Grounding - Blue (B) Grounding - Blue (B)
9 No connection No connection
10 Grounding - Sync. / Self test Grounding - Sync. / Self test
11 Grounding Grounding
12 DDC - SDA (Data) DDC - SDA (Data)
13 Horizontal Sync. Horizontal/Vertical Sync.
14 Vertical Sync. Not used
15 DDC - SCL (Clock) DDC - SCL (Clock)
➣
15 Pin D-SUB connector
01-BN68-00633J-00Eng.qxd 6/11/04 1:44 PM Page 6