User Manual

English-23

OPERATION

Memorizing the Channels

Your TV can memorize and store all of the available channels for both “off-air” (antenna)

and cable channels. After the available channels are memorized, use the CH and CH

buttons to scan through the channels. This eliminates the need to change channels by

entering the channel digits. There are three steps for memorizing channels: selecting a

broadcast source, memorizing the channels (automatic) and adding and deleting channels

(manual).

Selecting the Video Signal-source

Before your television can begin memorizing the available channels, you must specify the

type of signal source that is connected to the TV (i.e., an antenna or a cable system).

Press the MENU button to

display the menu.

Press the UP/DOWN

buttons to select “Channel”,

then press the ENTER

button.

Press the UP/DOWN

buttons to select “Air/CATV”,

then press the ENTER

button.

Repeatedly press the

UP/DOWN buttons to

cycle through these choices:

Air (antenna), STD, HRC or IRC

(all cable TV).

Press the UP/DOWN

buttons to select the Video

signal source, then press the

ENTER button.

Note : STD, HRC and IRC identify various types of cable

TV systems. Contact your local cable company to identify the

type of cable system that exists in your particular area.

At this point the signal source has been selected.

Proceed to “Storing Channels in Memory” (next page).

venus-04-en 6/28/03 8:16 AM Page 23