Наръчник за потребителя

GB
10
The AM aerial (for long and medium waves) can be:
Placed on a stable surface
Fixed to the wall (you must first remove the base)
The AM aerial connector terminals are located on the rear of the sys-
tem and are marked AM .
To avoid noise interference, check that the loudspeaker wires do
not run close to the aerial wires.
Always keep them at least 2 inches (5 cm) away.
Connecting the FM Aerial Connecting the AM (MW)/LW Aerial
There are two types of aerial, (depending on option chosen).
How to connect a SCREW TYPE aerial.
The FM aerial connector terminals are located on the rear of
the system and marked FM (75Ω).
Spread the T.form FM aerial out and attach the ends to a wall,
in the position providing the best reception.
On/Standby
Demo
AI Off
/Sleep
TUNER VDE/CD TAPE AUX
+
–
Volume
Disc Change
Disc 3Disc 2Disc 1
Disc Selection / Direct Play
Band SELECT /
Mono/ST
NTSC/PAL
Memory Repeat Program Deck 1/2 REV mode
Normal
TAPE TAPE REC
HI-SpeedREC/Pause
Mic Mixing
Phones
Mic 1 Mic 2
REC Lock
Echo
Shuffle
Tuning ModeDown
PREVIOUS NEXT
Up
Timer
On/Off
Timer
/Clock
R
S
u
r
r
o
u
n
d
P
o
w
e
r
S
.
B
a
s
s
E
Q
M
u
t
e
O
n
/
O
f
f
R
E
T
U
R
N
CD SYNC.
How to connect a COAXIAL TYPE aerial.
Connect a 75Ω antenna to the FM antenna terminal.
Plug the connector on the FM aerial supplied into the coaxial
socket (75Ω) marked FM on the rear of the system.
Follow the instructions given on Page 31 to tune into a radio
station, and determine the best position for the aerial.
If reception is poor, you may need to install an outdoor aerial.
To do so, connect an outdoor FM aerial to the FM socket on the
rear of the system using a 75Ω coaxial cable (not supplied).
1
2
FM FM
Connecting the SW Aerial (option)
How to connect a WIRE TYPE aerial.
Spread the SW aerial out and attach the ends to a wall, in the posi-
tion providing the best reception.
If reception is poor (e.g. distance from transmitter too great, walls
blocking the radio waves, etc.), install an outdoor aerial.
AM
FM(75Ω)
SW ANT.