manual de utilizador

GB
7
To take full advantage of your new mini-compact system, follow
these installation instructions before connecting the unit.
Install the system on a flat, stable surface.
Never place this unit on carpeting.
Never place this unit in an outdoor area.
Maintain an open space of approximately 4 inches (10 cm) on the
sides and rear of the system, for ventilation purposes.
Make sure that you have enough room to open the compact disc
compartment easily.
Place the loudspeakers at a reasonable distance on either side of
the system to ensure good stereo sound.
Direct the loudspeakers towards the listening area.
For optimum performance, make sure that both speakers are placed
at an equal distance above the floor.
Insert or replace remote control batteries when you:
Purchase the mini-compact system
Find that the remote control is no longer operating correctly
When replacing the batteries, use a new set of batteries and
never mix alkaline and manganese batteries.
Place your thumb on the position marked on the battery compartment
cover (rear of the remote control) and push the cover in the direction of
the arrow.
Insert two AAA, LR03 or equivalent batteries, taking care to respect
the polarities:
+ on the battery against + on the remote control
– on the battery against - on the remote control
Replace the cover by sliding it back until it clicks into position.
The loudspeaker connector terminals are located on the rear
of the system.
There are four terminals on the system:
Two for the left speaker (marked L)
Two for the right speaker (marked R)
To achieve the correct sound quality, connect the:
Red wire to the + terminals
Black wire to the - terminals
To connect a wire to a terminal, push the tab as far as it will go:
To the right on the system
Insert the wire, up to the plastic sheathing, in the hole.
Push the tab back:
To the left on the system, until it clicks into place
Result:
The wire is pinched and held firmly in place.
Repeat the operation for each wire.
The main lead must be plugged into an appropriate socket.
Before plugging your system into a main socket, you must check
the voltage setting (OPTIONAL). If the voltage of the socket does
not correspond to the setting on the rear of the unit, you may
seriously damage your system.
Check the position of the voltage selector on the rear of the system
(OPTIONAL).
Plug the main lead (marked AC Cord on the rear of the system) into
an appropriate socket.
Press the On/Standby button to switch your mini-component system on.
Where to Install Your
Mini-Compact System
Inserting Remote Control Batteries
Connecting the Loudspeakers
Connecting Your System to the
Power Supply
Standby
R
Mono/ST
TUNER CD TAPE AUX
Band
Disc 1
CD Repeat Disc Change
Open/Close
Disc 2 Disc 3
Vol.
Hi Speed
Dubbing
Program/Set
Phones
AI Off/Sleep Timer On/Off Timer/Clock
Demo
S.BASS
Down Preset/Manual Up
C
l
a
s
s
i
c
R
o
c
k
P
o
p
CD Synchro /
1
2
3
L
R
AC CORD
1
2
3
4
1
2
3