manual de utilizador

GB
8
The AM aerial (for long and medium waves) can be:
Placed on a stable surface
Fixed to the wall
The AM aerial connector terminals are located on the rear of the sys-
tem and are marked AM.
To avoid noise interference, check that the loudspeaker wires do
not run close to the aerial wires.
Always keep them at least 2 inches (5 cm) away.
There are two types of aerial, (depending on option chosen).
How to connect a COAXIAL TYPE aerial.
Connect a 75Ω antenna to the FM antenna terminal.
Plug the connector on the FM aerial supplied into the coaxial
socket (75Ω) marked FM on the rear of the system.
Follow the instructions given on Page 13 to tune into a radio
station, and determine the best position for the aerial.
If reception is poor, you may need to install an outdoor aerial.
To do so, connect an outdoor FM aerial to the FM socket on
the rear of the system using a 75Ω coaxial cable (not supplied).
How to connect a SCREW TYPE aerial.
The FM aerial connector terminals are located on the rear of
the system and marked FM (75Ω).
Spread the T.form FM aerial out and attach the ends to a wall,
in the position providing the best reception.
How to connect a WIRE TYPE aerial.
Spread the SW aerial out and attach the ends to a wall, in the posi-
tion providing the best reception.
If reception is poor (e.g. distance from transmitter too great, walls
blocking the radio waves, etc.), install an outdoor aerial.
Connecting the AM (MW)/LW Aerial Connecting the FM Aerial
Connecting the SW Aerial (option)
1
2
FM FM
FM AERIAL
(supplied)
75Ω COAXIAL CABLE
(not supplied)
R