Installation guide

10
Step-by-step installation guide
D. ALIGNING THE WALL PLATE
C
L
CAUTION: Wear gloves to avoid cutting
fingers on sharp edges.
Area E
Hole B
Hole A
Centerline
notches
Draw a Vertical Line
on Wall from Center
of Top Cabinet
Draw a Horizontal line on wall from
bottom of “Rear Wall Template”.
Horizontal Line
Horizontal Line
CAUTION: Wear gloves to avoid cutting fingers on sharp
edges.
1. Draw a Vertical line on the wall at the center of the 30"
wide space.
2. Draw a Horizontal line on the wall at the bottom of
“Rear Wall Template”.
3. Drill 5/8" holes for toggle bolts on 3 locations (Hole A,
Hole B, Hole C) but if the location of hole is same as
that of stud, drill a 3/16" hole for wood screw. In other
words, toggle bolt can not be used to the location of
stud.
NOTE: DO NOT MOUNT THE PLATE AT THIS
TIME.
NOTE: Holes A, B and C are inside area E. If none of A,
B and C is in a stud, find a stud somewhere in area E and
draw a forth circle to line up with the stud. It is important
to use at least one wood screw mounted firmly in a
stud to support the weight of the microwave. Set the
mounting plate aside.
DE68-03587B-EN.indd 10 2008-12-09 �� 4:13:09