Installation Guide 2021.03.23
Table Of Contents
- OTR_II_DE68-03587B-05_EN
- Important safety instructions
- Electrical requirements
- Hood exhaust
- Damage - Shipment/Installation
- Parts included
- Tools you will need
- Mounting space
- 1. Placement of the mounting plate
- 2. Installation types (choose A, B or C)
- Before you use your microwave
- OTR_II_DE68-03587B-05_CFR
- Consignes de sécurité importantes
- Exigences en matière de raccordement électrique
- Système d'évacuation de la hotte
- Dommages - Transport/Installation
- Pièces incluses avec l'appareil
- Outils nécessaires
- Espace de montage
- 1. Emplacement de la plaque de fixation
- 2. Types d'installation (A, B ou C)
- A. Système d'évacuation par le haut (conduit vertical)
- A1. Fixation de la plaque murale
- A2. Utilisation du gabarit du meuble haut pour la préparation du meuble haut
- A3. Procédure d'installation de l'adaptateur du système d'évacuation et contrôle de fonctionnement du registre
- A4. Montage du four micro-ondes
- A5. Réglage de l'adaptateur du système d'évacuation
- A6. Raccordement des conduits
- B. Circulation de l'air en circuit fermé (sans conduit et sans évents)
- C. Système d'évacuation par l'arrière (conduit horizontal)
- A. Système d'évacuation par le haut (conduit vertical)
- Avant d’utiliser votre four micro-ondes
22
Step-by-step installation guide
C5. MOUNT THE MICROWAVE OVEN
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use the handle
during installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used, case
damage may occur from over tightening screws.
NOTE: When mounting the microwave oven, thread
power cord through hole in bottom of top cabinet.
Keep it tight throughout Steps 1-3. Do not pinch cord
or lift oven by pulling cord.
1. Lift microwave, tilt it
forward, and hook slots
at back bottom edge
onto four lower tabs of
mounting plate.
2. Rotate front of oven
up against cabinet
bottom.
3. Insert a self-aligning screw through the top center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after
the threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord,
especially when mounting flush to bottom of
cabinet.
Cabinet Front
Filler Block
Microwave Oven Top
Self-Aligning Screw
Equivalent to
Depth of
Cabinet Recess
Cabinet Bottom Shelf
Equivalent
to Depth of
Cabinet Recess
Cabinet Bottom Shelf
Microwave Oven Top
Cabinet Front
Filler Block
Self-Aligning Screw
4. Attach the microwave oven to the top cabinet.
5. Insert 2 self-aligning screws
through outer top cabinet
holes. Turn two full turns on
each screw.
6. Tighten center screw
completely.
7. Tighten the outer two screws to the top of the
microwave oven. (While tightening screws, hold
the microwave oven in place against the wall and
the top cabinet.)
8. Install grease filter. See the Owner’s Manual
packed with the microwave.
OTR_II_DE68-03587B-05_EN.indd 22 6/19/2019 3:56:14 PM