Quick Guide

10
Step-by-step installation guide
D. ALIGNING THE WALL PLATE
C
L
Draw a Horizontal line on wall from
bottom of “Rear Wall Template˝.
Draw a Vertical Line on
Wall from Center
of Top Cabinet
Horizontal Line
Horizontal Line
Area E
Centerline
notches
Hole A
Hole B
Hole C
CAUTION: Wear gloves to avoid cutting fingers on
sharp edges.
1. Draw a Vertical line on the wall at the center of
the 30˝ wide space.
2. Draw a Horizontal line on the wall at the bottom
of “Rear Wall Template”.
3. Drill ⅝˝ holes for toggle bolts on 3 locations (Hole
A, Hole B, Hole C) but if the location of hole is
same as that of stud, drill a
3
/
16
˝ hole for wood
screw. In other words, toggle bolt can not be
used to the location of stud.
NOTE: DO NOT MOUNT THE PLATE AT THIS
TIME.
NOTE: Holes A, B and C are inside area E. If none
of A, B and C is in a stud, find a stud somewhere
in area E and draw a forth circle to line up with the
stud. It is important to use at least one wood
screw mounted firmly in a stud to support the
weight of the microwave. Set the mounting plate
aside.
SMH8165_XAA_DE68-03587A-12_EN.indd 10SMH8165_XAA_DE68-03587A-12_EN.indd 10 2022-01-20 오전 10:05:162022-01-20 오전 10:05:16