Quick Guide

12
Step-by-step installation guide
A. OUTSIDE TOP EXHAUST
(VERTICAL DUCT)
A1. INSTALLATION PROCEDURE FOR EXHAUST
ADAPTOR AND PROPER DAMPER
OPERATION CHECK
Blower Plate
Damper
Exhaust Adaptor
Retaining Hooks
Back of
Microwave
Oven
1. Slide exhaust adaptor following the instructions show
in diagram.
2. Make sure tape securing damper is removed and
damper pivots easily before mounting microwave.
• You will need to make adjustments to assure proper
alignment with your house exhaust duct after the
microwave is installed.
A2. ADJUST THE EXHAUST ADAPTOR
Open the top cabinet and adjust the exhaust adaptor to
connect to the house duct.
Damper
For Side-toSide
Adjustment, Slide the
Exhaust Adaptor as
Needed
Back of
Microwave
Oven
NOTE: The house duct is needed to connect to the
exhaust adaptor after installation completion.
House Duct
B. RECIRCULATING
(NON-VENTED DUCTLESS)
B1. ADAPTING MICROWAVE BLOWER FOR
RECIRCULATION
1. Remove and save screw that holds blower plate to
microwave.
2. Lift up the blower plate.
Back of
Microwave Oven
Blower
Retaining
Screws
NOTE: The exhaust adaptor with damper is not needed
for recirculating models. You may want to save them for
possible future use.
3. Remove screw holds blower mortor and carefully pull
out the blower unit. The wires will extend far enough
to allow you to adjust the blower unit.
CAUTION: Do not touch blade of blower for preventing
crack and break. Hold outer case when the blower pull
out or back into.
SMH8165_XAA_DE68-03587A-12_EN.indd 12SMH8165_XAA_DE68-03587A-12_EN.indd 12 2022-01-20 오전 10:05:162022-01-20 오전 10:05:16