User Manual

15
Step-by-step installation guide
B. ATTACH THE MOUNTING
PLATE TO THE WALL
Attach the plate to the wall using toggle bolts. At
least one wood screw must be used to attach the
plate to a wall stud.
1. Remove the toggle wings from the bolts.
2. Insert the bolts into the mounting plate through
the holes designated to go into drywall, and then
reattach the toggle wings so that ¾" of the bolt
protrudes beyond the wing.
INSTALLATION OVERVIEW
A. Prepare the Rear Wall (for outside back exhaust/
horizontal duct only)
B. Attach the Mounting Plate to the Wall
C. Prepare the Cabinet above
D. Mount the Microwave Oven
E. Connect the Ductwork (for outside top
exhaust/vertical duct only)
A. PREPARE THE REAR
WALL FOR OUTSIDE BACK
EXHAUST
You need to cut an opening in the rear wall for
outside exhaust.
C
L
• Read the instructions for outside back exhaust
on the REAR WALL TEMPLATE.
• Tape the REAR WALL TEMPLATE to the rear
wall.
• Cut the opening, following the instructions on
the REAR WALL TEMPLATE.
CAUTION: Do not cut an opening in the rear wall if
you are installing the microwave with vertical duct or
non-vented ductless ventilation.
3. INSTALLATION
ME21R7051SS_SG_AA_DE68-04577A-00_EN.indd 15 3/21/2019 12:37:19 PM