Quick Guide

10
Step-by-step installation guide
D. ALIGNING THE WALL PLATE
C
L
CAUTION: Wear gloves to avoid cutting
fingers on sharp edges.
Area E
Hole B
Hole A
Centerline
notches
Draw a Vertical Line
on Wall from Center
of Top Cabinet
Draw a Horizontal line on wall from
bottom of “Rear Wall Template”.
Horizontal Line
Horizontal Line
Draw a horizontal line on the wall along
the bottom of the “Rear Wall Template”.
Draw a vertical line
on the wall to mark
the center of the
cabinet above.
Horizontal Line
Horizontal Line
Area E
Centerline
notches
Hole A
Hole B
CAUTION: Wear gloves to avoid cutting fingers on
sharp edges.
1. Draw a horizontal line on the wall at the bottom of
the “Rear Wall Template”.
2. Drill ⅝" holes for toggle bolts in 3 locations (Hole
A, Hole B, Hole C) as shown in the illustration
above. If the location of a hole lines up with a
stud, drill a
3
/
16
" hole for a wood screw. You
cannot use a toggle bolt to attach the wall plate
to a stud.
NOTE: DO NOT MOUNT THE PLATE AT THIS
TIME.
3. Holes A, B and C are inside area E. If none of
these holes line up with a stud, find a stud in area
E that lines up with a hole circle in Area E, and
then drill a
3
/
16
" hole into it for a wood screw. You
must have at least one wood screw mounted
firmly into a stud to support the weight of the
microwave. Set the mounting plate aside.
ME21R7051SS_SG_AA_DE68-04577A-01_EN.indd 10ME21R7051SS_SG_AA_DE68-04577A-01_EN.indd 10 2021-03-25 오전 11:32:302021-03-25 오전 11:32:30