Quick Guide

12
Step-by-step installation guide
A. OUTSIDE TOP EXHAUST
(VERTICAL DUCT)
A1. INSTALLATION PROCEDURE FOR THE
EXHAUST ADAPTOR AND PROPER DAMPER
OPERATION CHECK
The exhaust Adaptor and
Damper are shipped assembled
and attached to the filler-upper.
1. Slide the exhaust adaptor into place as shown in the
diagram above.
2. Make sure the tape securing the damper is removed
and damper pivots easily before you mount the
microwave.
CAUTION: You will need to make adjustments to assure
proper alignment with your house exhaust duct after the
microwave is installed.
A2. ADJUST THE EXHAUST ADAPTOR
After you have installed the microwave, you will need to
open the top cabinet and adjust the exhaust adaptor so
that you can connect it to the house duct.
For Front-to-Back
Adjustment, Slide the
Exhaust Adaptor as
Needed
Blower Plate
Back of
Microwave
Damper
NOTE: You must attach the house duct to the exhaust
adaptor after installation is complete.
House Duct
House Duct
B. RECIRCULATING
(NON-VENTED DUCTLESS)
B1. ADAPTING THE MICROWAVE BLOWER FOR
RECIRCULATION
2. Lift up the
blower plate.
1. Remove and save the screws
that hold the blower plate to the
microwave.
Back of
Microwave
NOTE: The exhaust adaptor with the damper is not
needed for recirculating models. You may want to save
them for possible future use.
ME21R7051SS_SG_AA_DE68-04577A-01_EN.indd 12ME21R7051SS_SG_AA_DE68-04577A-01_EN.indd 12 2021-03-25 오전 11:32:302021-03-25 오전 11:32:30