Quick Guide

3
General information
IMPORTANT SAFETY INSTRUCTIONS
This product requires a three-prong grounded outlet.
The installer must perform a ground continuity check on
the power outlet box before beginning the installation
to ensure that the outlet box is properly grounded. If
not properly grounded, or if the outlet box does not
meet electrical requirements noted (under ELECTRICAL
REQUIREMENTS), a qualified electrician should be
employed to correct any deficiencies.
Insure proper
ground exists
before use
CAUTION: For personal
safety, remove the house
fuse or open the circuit
breaker before beginning the
installation to avoid severe
or fatal shock injury.
CAUTION: For personal safety, the mounting
surface must be capable of supporting the cabinet
load in addition to the added weight of this 69
pound product, plus additional oven loads of up to
50 pounds or a total weight of 109 pounds.
CAUTION: For personal safety, do not install this
product in cabinetry configured as an island or a
peninsula. The microwave oven must be mounted
to BOTH a top cabinet AND a wall.
NOTE: For easier installation and personal safety,
we recommend that two people install this
product.
IMPORTANT – PLEASE READ CAREFULLY. FOR
PERSONAL SAFETY, THIS APPLIANCE MUST BE
PROPERLY GROUNDED TO AVOID SEVERE OR
FATAL SHOCK.
Insure proper
ground exists
before use
Insure proper
ground exists
before use.
The power cord of this
appliance is equipped with a
three-prong (grounding) plug
which mates with a standard
three-prong (grounding) wall
receptacle to minimize the
possibility of electric shock
hazard from this appliance.
You should have the wall receptacle and circuit
checked by a qualified electrician to make sure the
receptacle is properly grounded.
If you have a standard two-prong wall receptacle,
it is very important to have it replaced with a
properly grounded three-prong wall receptacle,
installed by a qualified electrician.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT,
DEFORM OR REMOVE ANY OF THE PRONGS
FROM THE POWER CORD. DO NOT USE WITH AN
EXTENSION CORD.
ELECTRICAL
REQUIREMENTS
Product rating is 120 volts AC, 60 Hertz, 14.5 amps
and 1.7 kilowatts.This product must be connected to a
supply circuit of the proper voltage and frequency. Wire
size must conform to the requirements of the National
Electrical Code or the prevailing local code for this
kilowatt rating. The power supply cord and plug should
be brought to a separate branch circuit single grounded
outlet of at least 15 A and max of 20 A. The outlet box
should be located in the cabinet above the microwave
oven. The outlet box and supply circuit should be
installed by a qualified electrician and conform to the
National Electrical Code or the prevailing local code.
ME21R7051SS_SG_AA_DE68-04577A-01_EN.indd 3ME21R7051SS_SG_AA_DE68-04577A-01_EN.indd 3 2021-03-25 오전 11:32:292021-03-25 오전 11:32:29