Installation Manual
12
Installing the Wi-Fi Kit
6. Activate the Wi-Fi Kit.
•Whe
n power is supplied, all indicators on the kit illuminate until the system boots completely.
• After the system operates, tracking is performed automatically.
7. Tracking
࢘
Tracking: Detects indoor units that are connected to the Wi-Fi Kit. The indoor unit detects the connection
to the Wi-Fi Kit. Tracking is required to monitor or control the system air conditioner by using the
Wi-Fi Kit.
• The Wi-Fi Kit automatically performs tracking when activated. The (
) ( ) indicators on the Wi-Fi Kit
blink while in tracking.
• When no indoor unit is detected by tracking, the (
) indicator blinks for 10 seconds and the kit attempts
the tracking again. In this case, make sure that the communication cables between the indoor and outdoor
units are connected properly.
• When there happens any change in the installation of indoor and outdoor units, manually run the tracking
by pressing the (SW3,
庢- ) button inside the Wi-Fi Kit.
• When the tracking is completed but all the connected indoor units have the central control option
disabled, the (
) indicator illuminates for 10 seconds and the ( ) indicator blinks. Then the kit
attempts the tracking again. In this case, check and change the the central control option for indoor
units. When the central control option is disabled, you cannot control indoor units via the Wi-Fi Kit.
• To control indoor units by using a mobile phone, wait until the tracking is completed and then connect
the Wi-Fi Kit to a wireless router.
• The (
) indicator does not turn off until the Wi-Fi Kit is connected to a wireless router after tracking.
CAUTION
NOTE
zvsGvjmG~TmGrp{G㡔⤱䛙Gpiptluki]_TWWWWWhTWWUGGGXY YWX`TWZTY\GGG㝘䟸GZaX\a\]