User Manual

GB
9
The AM aerial (for medium waves) can be:
◆ Placed on a stable surface
◆ Fixed to the wall (you must first remove the base)
The AM aerial connector terminals are located on the rear of the system
and are marked AM.
To avoid noise interference, check that the loudspeaker wires do
not run close to the aerial wires.
Always keep them at least 2 inches (5 cm) away.
How to connect a COAXIAL TYPE aerial.
◆ Connect a 75Ω antenna to the FM antenna terminal.
◆ Plug the connector on the FM aerial supplied into the coaxial socket
(75Ω) marked FM on the rear of the system.
◆ Follow the instructions given on Page 12 to tune into a radio station,
and determine the best position for the aerial.
◆ If reception is poor, you may need to install an outdoor aerial.
To do so, connect an outdoor FM aerial to the FM socket on the rear
of the system using a 75Ω coaxial cable (not supplied).
Connecting the AM (MW) Aerial Connecting the FM Aerial
Connecting the SW Aerial
How to connect a WIRE TYPE aerial.
Spread the
SW aerial out and attach the ends to a wall, in the position
providing the best reception.
If reception is poor (eg. distance from transmitter too great, walls
blocking the radio waves, etc.), install an outdoor aerial.
MM-L5000-NO RDS(GB) 5/19/03 19:15 Page 9