MICRO COMPONENT SYSTEM WITH REMOTE CONTROL MM-N4 Instruction Manual Sleep Timer/ Clock Timer On/Off On/Standby EQ Preset Program /Set Power Sound CD Repeat Mono/ST. AUX TUNER Band TAPE CD VOL. CD Tuning Mode VOL. Downloaded From Disc-Player.
Safety Warnings GB CLASS 1 LASER PRODUCT CLASS 1 LASER PRODUCT KLASSE 1 LASER PRODUKT LUOKAN 1 LASER LAITE KLASS 1 LASER APPARAT PRODUCTO LASER CLASE 1 CAUTION RISK OF ELECTRIC SHOCK. DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE REAR COVER, NO USER SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This Compact Disc player is classified as a CLASS 1 LASER product.
Contents You have just purchased a SAMSUNG micro component system. Please take the time to read these instructions, as they will enable you to set up your player easily and take full advantage of its features. INSTALLING YOUR MICRO COMPONENT SYSTEM Safety Warnings ........................................................................................................................... 2 Where to Install Your Micro Component System .........................................................................
Where to Install Your Micro-Component System GB To take full advantage of your new MICRO component system, follow these installation instructions before connecting the unit. Install the system on a flat, stable surface. Never place this unit on carpeting. Never locate this unit in an outdoor area. Maintain an open space of approximately 4 inches (10 cm) on the sides and rear of the system, for ventilation purposes. Make sure that you have enough room to open the compact disc compartment easily.
Connecting the AM(MW)/LW Aerial The AM(MW)/LW aerial (for long and medium waves) can be: Connecting the FM Aerial There are two types of aerials, follow the instructions below (depending on option chosen). GB Placed on a stable surface Fixed to the wall (you must first remove the base) The AM aerial connector terminals are located on the rear of the system and are marked AM. 1 To avoid noise interference, check that the loudspeaker wires do not run close to the aerial wires.
Setting the Clock GB Listening to a Compact Disc Your system is equipped with a clock which allows you to turn your system on and aff automatically. You should set the clock: When you purchase the Micro component system After a power failure You can play 12 cm or 8 cm compact discs without an adapter. 1 2 Select the CD function by pressing CD on the front panel. 3 Place your disc in the compartment, with the label on the disc facing upwards.
Precautions When Using Compact Discs Programming the Order of Playback To guarantee hours of enjoyable listening with your compact discs: You can decide for yourself: The order in which you listen to the tracks The tracks to which you do not wish to listen This feature can be combined with the Repeat function.
Checking and Changing Programmed Tracks You can check and change your selection of tracks at any time. GB You must have selected at least one track. 1 Press STOP ( ) once if you have started listening to the selection. 2 Press Program/Set. Each time you press Program/Set, the next selection is displayed. 3 Press Program/Set one or more times until the track to be changed is displayed.
Searching for and Storing the Radio Stations(continued) 6 Adjust the volume by: Pressing VOLUME or on the front panel or Pressing the VOL. + or - buttons on the remote control 7 Select the stereo or mono mode by pressing Mono/ST. Result: The MONO indicator is displayed when selected. 8 If you do not want to store the radio station found, revert to Step 4 and search for another station. Otherwise: a Press Program/Set. Result: The program number and PROGRAM are displayed for a few seconds.
Listening to a Cassette GB 1 2 3 Maintaining the Sound Quality Switch the system on by pressing On/Standby. Select the TAPE function by pressing TAPE on the front panel. Open the cassette deck by pushing on the corner of the cover marked PUSH EJECT until you hear a click and then releasing it. Insert the pre-recorded cassette with the open edge of the tape facing downwards. Close the deck by pushing on it until it clicks into place. Press the play( ) button. Result: The cassette starts playing.
Recording a Radio Programme You can record a radio programme of your choice and listen to it at a later date. 1 Insert a blank cassette in the cassette deck. 2 Press TUNER/Band to select the radio function. 3 Select the radio station that you wish to records. 4 To start recording, press the REC/Pause button. Result: Recording starts immediately. 5 To stop recording temporarily, press the REC/Pause button. 6 When you wish to stop recording, press the STOP ( Sleep CD Repeat Mono/ST. ) button.
Timer Function GB The timer enables you to switch the system on or off at specific times. Example: You wish to wake up to music every morning. If you no longer want the system to be switched on or off automatically, you must cancel the timer. Before setting the timer, check that the current time is correct. For each step, you have a few seconds to set the required options. If you exceed this time, you must start again.
Sleep Timer Equalizer You can set the system to switch off automatically. Example: You wish to fall a sleep to music. 1 2 Press Sleep.
About RDS broadcasting This unit has the RDS(Radio Data System) function, which enables for the various information such as broadcasting station, radio text, time and 17 types of programs(News, Rock, Classic, etc.) to be received from the FM RDS station together with the normal radio signal. 1 2 3 PS NAME RT CT Current FM frequency Displays the name of broadcasting station. Press the Display button to select the PS NAME. "PS NAME” appears on the display.
PTY(Program Type) indication and PTY-SEARCH function The PTY information is composed of an identification symbol, which helps the FM radio to recognize the program type of each FM station. The below 17 PTY information is shown on the display by pressing the PTY button. Display If the PTY MODE which agrees with the PTY MODE selected in the course of auto-search, isn't received, it is returned to the first frequency at beginning the PTY SEARCH and the auto-search and PTY SEARCH are suspended.
Power sound function GB Connecting to an External Source This machine is equipped with the function of POWER SOUND, which amplifies bass treble output to twice as much for powerful real surround-sound. 1 Press the Power Sound button on the front panel. Result: P--SOUND is displayed for a few seconds. A more powerful resonant sound is diffused. 2 To cancel this function, press Power Sound again.
Safety Precautions Before Contacting the After-Sales Service The following diagrams illustrate the precautions to be taken when using or moving your Micro component system. 10% It always takes a little time to become familiar with a new appliance. If you have any of the problems listed below, try the solutions given. They may save you the time and inconvenience of an unnecessary service call.
Front Panel View GB 9 1 10 Band TUNER TAPE CD AUX 11 On/Standby Tuning Mode 2 n ow REC/Pause Up D 12 Volume 4 13 SS EQ Pres et S.BA 3 Repeat(A<->B) Mute 14 PHONE Pty 5 RDS Display CD Synchro Power Sound 6 7 15 8 16 1. Function selection buttons 10. AUX button 2. On/Standby button 11. Function control buttons 3. Equalizer preset button 12. REC/Pause button 4. Mute button 13. S. BASS button 5. Headphones jack 14. Repeat (A 6. RDS Pty button 7.
Remote Control 9 On/Standby Timer On/Off Timer/ Clock 1 10 11 EQ Preset 2 3 Sleep Power Sound Program /Set CD Repeat Mono/ST. AUX TUNER 4 12 13 14 5 Band TAPE 6 CD 15 16 17 18 7 19 VOL. Tuning Mode CD 8 CD VOL. 20 21 1. On/Standby button 12. AUX button 2. EQ Preset button 13. Program/Set button 3. Power Sound button 14. Frequency band selection button 4. Sleep button 15. Mono/Stereo button 5. CD Repeat button 16. Tape Playback button 6.
Technical Specifications Rear Panel View GB SAMSUNG strives to improve its products at all times. Both the design specifications and these user instructions are thus subject to change without notice. 1 ANTENNA AM SW ANT CD DIGITAL OUT DC JACK FM (75Ω) Option DC IN 12V 2 3 4 VOLTAGE SEL. AC CORD 5 1.
THIS APPLIANCE IS MANUFACTURED BY: ELECTRONICS Downloaded From Disc-Player.
