User Manual

Basic Setup 1-6
Setup 1-6
Basic Setup 1-7
Setup 1-7
Connecting the phone cord
You need to connect a phone line to the MovieBeam receiver so that it can communicate with
MovieBeam services, about once every two weeks or as needed. For better service, it’s best to
keep the phone line plugged in at all times. If there is no phone jack near your TV set, you can
connect the phone line once every two weeks, or you might consider using a wireless phone jack,
which converts an electrical outlet into a phone jack. We don’t provide you with this device but
you can get it at the same retailers that carry the MovieBeam receiver.
Connect one end of the phone cord to the phone jack on the back of the MovieBeam receiver.
Connect the other end to a phone wall jack. If the wall jack is being used, plug the phone line
splitter into the wall jack, then connect both phone lines into it. The phone line splitter will not
interfere with your phone. Your phone line will not be tied up because movies are not sent via the
phone line.
PH
ONE�CORD-
M
ovieBeam
S
/
P
D
I
F
U
S
B
PH
O
NE�CORD-
M
ovieBeam