User Manual

Basic Setup 1-14
Setup 1-14
Basic Setup 1-15
Setup 1-15
6. TV with several inputs. All inputs are used. Audio from the
other devices such as DVDs or VCRs is passed through the Movie-
Beam receiver to surround sound system.
When the surround sound has only two audio inputs, you can pass the audio signal through the
MovieBeam receiver as shown below. You will need the following cables:
- A/V cable (provided with the receiver)
- Two video cables (one yellow connector on each end)*
- Two audio cables (red and white connector on each end)*
*cables not included with the MovieBeam receiver.
1. Connect one end of the A/V cable to the MovieBeam receiver IN connectors. Plug the other
end into the OUT connectors on the VCR or other device.
2. Connect the red and white A/V connectors to the MovieBeam receiver audio OUT connectors.
Plug the other end into the surround sound audio IN connectors.*
3. Connect the red and white A/V connectors to the surround sound audio IN connectors. Plug
the other end into the DVD (or other device) audio OUT connectors.*
4. Connect the yellow connector* to the MovieBeam receiver video OUT connector and the
other yellow connector to the video IN connector on the TV.
5. Connect the yellow connector* to the TV video IN connector and the other yellow connector
to the video OUT connector on the DVD or other device.