User Manual

Finishing Setup, Renting and Watching Movies 3-8
Turning on the MovieBeam receiver and your TV
The first time you plug in your MovieBeam receiver, you may hear the disk drive make some
sounds as it boots up. A welcome screen will display with further instructions. The welcome screen
may display for as long as 5 minutes.
Your MovieBeam receiver is always powered “on.” When it is in standby mode and not sending
video to your TV, the LED will be orange. You will know that the receiver is sending video to your
TV if the green LED is on.
If you are not getting images on your TV, find either the “Input” or “TV/VCR” button your
TV’s remote control. Keep pressing it until it you select the right input and the welcome page
shows on your TV screen.
An animated sequence will guide you through the rest of the setup. Follow the prompts to set up
dialing, adjust the antenna, learn about the MovieBeam receiver’s features and rent a movie.