User Manual

Maintenance, Troubleshooting and Endnotes 4-3
No power (Continued from previous page.)
What’s wrong
The MovieBeam receiver is plugged
into a switched outlet which is
switched off.
How to fix it
Some wall outlets get power only when you
turn a light switch on. If you have a light switch
that you never really knew what it did...this
might be it. Turn the switch on and leave it on.
The MovieBeam receiver is plugged
into a power strip that is switched
off.
Turn the power strip on. Power on is often
indicated by a little red light.
Remote control doesn’t work
Any time the remote doesn’t work, you can still watch movies and control the
MovieBeam receiver using the buttons on the receiver’s front panel.
What’s wrong
Batteries are missing, dead, or
incorrectly installed.
How to fix it
Install two AA batteries as shown on p. 3-2.
Remote is being used too far from
the MovieBeam receiver.
Move the remote closer to the receiver. Be sure
the MovieBeam receiver is in the direct path of
the remote.
The dog ate my remote. If your remote is lost or damaged, contact
customer service at 1-866-865-1500.